Polypropylene Hollow-Fiber Membrane Made Using the Dissolution-Induced Pores Method
Open Access
Abstract
The efficient preparation of hydrophilic polypropylene membranes has always been a problem. Here, a twin-screw extruder was used to melt-blend ethylene-vinyl alcohol copolymer and polypropylene; then, hollow fibers were extrusion-molded with a spinneret and taken by a winder; after this, dimethyl sulfoxide was used to dissolve the ethylene-vinyl alcohol copolymer of the fiber to obtain a polypropylene hollow-fiber membrane. This procedure was used to study the effects of different contents and segment structure of ethylene-vinyl alcohol copolymer on the structure and filtration performance of the membranes; furthermore, the embedded factor and blocked factor were used to evaluate the ethylene-vinyl alcohol copolymer embedded in the matrix without dissolving and or being completely blocked in the matrix, respectively. The results show that the increase in ethylene-vinyl alcohol copolymer could reduce the embedded factor and increase the blocked factor. The increase in the polyethylene segments of ethylene-vinyl alcohol copolymer could increase both the embedded factor and blocked factor. The water permeation of the membrane reached 1300 Lm−2·h−1·bar−1 with a 100% rejection of ink (141 nm) and the elongation at break reached 188%, while the strength reached 22 MPa. The dissolution-induced pores method provides a completely viable alternative route for the preparation of polypropylene membranes.Keywords
Funding Information
- National Natural Science Foundation of China (51873034)
- Fundamental Research Funds for the Central Universities. Supported by ‘the Fundamental Re-search Funds for the Central Universities and Graduate Student Innovation Fund of Donghua University (2019021)
This publication has 45 references indexed in Scilit:
- Effect of annealing on the morphology of porous polypropylene hollow fiber membranesMacromolecular Research, 2014
- Fibronectin coating of oxygenator membranes enhances endothelial cell attachmentBioMedical Engineering OnLine, 2013
- In situ reinforced and flame-retarded polycarbonate by a novel phosphorus-containing thermotropic liquid crystalline copolyesterPolymer, 2011
- Influence of polypropylene membrane surface porosity on the performance of membrane distillation processJournal of Membrane Science, 2007
- Experimental Study of the Effect of Membrane Porosity on Membrane Absorption ProcessSeparation Science and Technology, 2006
- Effects of nucleating agents on preparation of polypropylene hollow fiber membranes by melt spinning processMacromolecular Research, 2002
- Morphology structure study of polypropylene hollow fiber membrane made by the blend‐spinning and cold‐stretching methodJournal of Applied Polymer Science, 2002
- Mechanical properties of biaxially drawn films of ultra-high molecular weight polyethylene dried gelsPolymer, 1993
- Microporous Hollow Fiber Membranes for Artificial Lungs Made of Polypropylene/Liquid Paraffin Mixtures. II. Morphological Change of Microporous Hollow Fiber Membranes for Artificial Lungs Induced by Cooling.KOBUNSHI RONBUNSHU, 1993
- Microporous Hollow Fiber Membranes for Artificial Lungs Made of Polypropylene/Liquid Paraffin Mixtures. I. Influence of Molecular Weight of Polypropylene and a Nucleating Agent on Polypropylene Microporous Hollow Fiber Membranes for Artificial Lungs.KOBUNSHI RONBUNSHU, 1993