Characterization of surface‐modified hollow fiber polyethersulfone membranes prepared at different air gaps
- 26 January 2007
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 104 (2) , 710-721
Abstract
Hollow fibers were spun from a solution of surface‐modifying macromolecule blended polyethersulfone in dimethyl acetamide by using dry‐wet spinning method at different air gaps and at room temperature. The air gap was varied from 10 to 90 cm. The ultrafiltration performance of hollow fibers was studied by using aqueous solutions of polyethylene glycols and polyethylene oxides of different molecular weights. Significant difference in surface morphology between the inner and outer surface of the hollow fibers was observed by atomic force microscopy (AFM). Similar results were obtained by contact angle measurement and XPS. Mean pore sizes of the inner surface and outer surface were calculated from AFM images and compared with the pore sizes obtained from mass transport data. Pore size distribution curves were drawn from both data, i.e., from AFM images and mass‐transport data, both methods gave similar results. Roughness parameters of the inner and outer surfaces and the sizes of nodular aggregates on both surfaces were measured. An attempt was made to correlate the above parameters with the performance of the membranes. Unexpected values of contact angles of both inner surface and outer surface were obtained. It was observed that the studied membranes could be put into two groups: (i) the membranes fabricated between 10 and 50 cm air gap and (ii) fabricated at higher than 50 cm air gap. A plausible mechanism for the unexpected results was discussed. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 710–721, 2007Keywords
This publication has 24 references indexed in Scilit:
- Structural and performance study of micro porous polyetherimide hollow fiber membranes prepared at different air-gapJournal of Membrane Science, 2004
- Characterization of polyethersulfone hemodialysis membrane by ultrafiltration and atomic force microscopyJournal of Membrane Science, 2004
- Study on surface modification by surface‐modifying macromolecules and its applications in membrane‐separation processesJournal of Applied Polymer Science, 2003
- Study on the Kinetics of Surface Migration of Surface Modifying Macromolecules in Membrane PreparationMacromolecules, 2002
- Structural and performance study of microporous polyetherimide hollow fiber membranes made by solvent-spinning methodJournal of Membrane Science, 2001
- Surface properties of perfluoroalkylethyl acrylate/n-alkyl acrylate copolymersJournal of Applied Polymer Science, 1999
- Application of surface modifying macromolecules in polyethersulfone membranes: Influence on PES surface chemistry and physical propertiesJournal of Applied Polymer Science, 1999
- Development of membranes with low surface energy to reduce the fouling in ultrafiltration applicationsJournal of Membrane Science, 1997
- Wetting criteria for the applicability of membrane distillationJournal of Membrane Science, 1987
- Side Chain Crystallization of n-Alkyl Polymethacrylates and Polyacrylates1Journal of the American Chemical Society, 1954