Ultrasensitive electrochemical sensor based on synergistic effect of Ag@MXene and antifouling cyclic multifunctional peptide for PD-L1 detection in serum
- 10 June 2024
- journal article
- research article
- Published by Springer Nature in Microchimica Acta
- Vol. 191 (7) , 1-14
Abstract
A sensing interface co-constructed from the two-dimensional conductive material (Ag@MXene) and an antifouling cyclic multifunctional peptide (CP) is described. While the large surface area of Ag@MXene loads more CP probes, CP binds to Ag@MXene to form a fouling barrier and ensure the structural rigidity of the targeting sequence. This strategy synergistically enhances the biosensor’s sensitivity and resistance to contamination. The SPR results showed that the binding affinity of the CP to the target was 6.23 times higher than that of the antifouling straight-chain multifunctional peptide (SP) to the target. In the 10 mg/mL BSA electrochemical fouling test, the fouling resistance of Ag@MXene + CP (composite sensing interface of CP combined with Ag@MXene) was 30 times higher than that of the bare electrode. The designed electrochemical sensor exhibited good selectivity and wide dynamic response range at PD-L1 concentrations from 0.1 to 50 ng/mL. The lowest detection limit was 24.54 pg/mL (S/N = 3). Antifouling 2D materials with a substantial specific surface area, coupled with non-straight chain antifouling multifunctional peptides, offer a wide scope for investigating the sensitivity and antifouling properties of electrochemical sensors. Graphical abstractKeywords
Funding Information
- National Natural Science Foundation of China (61875114)
This publication has 68 references indexed in Scilit:
- Electrochemical Methods for the Analysis of Clinically Relevant BiomoleculesChemical Reviews, 2016
- Expression of PD-L1 in triple-negative breast cancer based on different immunohistochemical antibodiesJournal of Translational Medicine, 2016
- Quantitative Assessment of the Heterogeneity of PD-L1 Expression in Non–Small-Cell Lung CancerJAMA Oncology, 2016
- Surface and Interface Engineering of Electrode Materials for Lithium‐Ion BatteriesAdvanced Materials, 2014
- Electrochemical Sensors and Biosensors Based on Nanomaterials and NanostructuresAnalytical Chemistry, 2014
- Ultra-low fouling peptide surfaces derived from natural amino acidsBiomaterials, 2009
- Single-molecule force spectroscopy: optical tweezers, magnetic tweezers and atomic force microscopyNature Methods, 2008
- Glucose biosensor based on glucose oxidase immobilized in sol?gel chitosan/silica hybrid composite film on Prussian blue modified glass carbon electrodeAnalytical and Bioanalytical Chemistry, 2005
- Effect of Side Chains on Turns and Helices in Peptides of β3-Aminoxy AcidsJournal of the American Chemical Society, 2004
- Peptide and Protein Recognition by Designed MoleculesChemical Reviews, 2000