Indentation Size Effect of Composite A356 + 6%FA Subjected to ECAP
Open Access
Abstract
In this study, metal matrix-based composite (MMC) was subjected to Equal Chanel Angular Pressing (ECAP) in several passes to determine the influence of deformation on the hardness of the samples. Composite based on A356 aluminum alloy and reinforced with Fly Ash (FA) particles was obtained by the compo casting method. The microstructural analyses and microhardness measurements were performed on the cast and pressed samples. Vickers hardness measurement of composite samples was performed with different indentation load sizes: HV0.02, HV0.05, HV0.1 and HV0.2. Results showed that hardness increases after each ECAP pass. The lowest hardness value of 42 (HV0.02) as well as the lowest arithmetical mean value of 46 (HV0.2) was measured at the cast composite. The greatest composite hardness of 107 (HV0.1) and the highest arithmetical mean value of 94 (HV0.1) was measured at the three-time pressed sample. The mathematical model named Meyer’s law was used for data analysis. In the cast sample, a decrease in hardness was detected with increasing indentation load, termed Indentation Size Effect (ISE), was confirmed with Meyers index n = 1.9112 < 2. Pressed samples showed opposite behavior—an increase in hardness with increasing indentation load—where Meyers index n > 2 indicated Reverse Indentation Size Effect (RISE). For all samples, a high coefficient of determination R2 > 0.99 confirmed that Meyer’s law described this phenomenon well.Keywords
This publication has 20 references indexed in Scilit:
- A review on the production of metal matrix composites through stir casting – Furnace design, properties, challenges, and research opportunitiesJournal of Manufacturing Processes, 2019
- Effect of Fly Ash Content and Applied Load On Wear Behaviour of AA6063 Aluminium AlloyIOP Conference Series: Materials Science and Engineering, 2018
- Toxicity and environmental and economic performance of fly ash and recycled concrete aggregates use in concrete: A reviewHeliyon, 2018
- Hardness - Yield Strength Relation of Al-Mg-Si AlloysIOP Conference Series: Materials Science and Engineering, 2018
- THE AUTOMATIC TESTERS IN MICROHARDNESS MEASUREMENT AND ISE EFFECTActa Metallurgica Slovaca, 2016
- Comparative Study on Cavitation Erosion Resistance of A356 Alloy and A356FA5 CompositeTransactions of the Indian Institute of Metals, 2016
- Reverse indentation size effect of a duplex steelMetallic Materials, 2016
- A356 Aluminum Alloy and applications- A ReviewInternational Journal of Advanced Materials Manufacturing and Characterization, 2014
- Synthesis and Characterization of Al6061-Fly Ashp-SiCp Composites by Stir Casting and Compocasting MethodsEnergy Procedia, 2013
- Hardness and indentation load-size effect in Al2O3-SiC nanocompositeMetallic Materials, 2011