Design and stability analysis for an autonomous DC microgrid with constant power load
Authors:
- 1 March 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3409-3415
Abstract
Fuel cell is a promising source in autonomous dc microgrid. Hybridization of fuel cell with battery is commonly implemented to overcome slow dynamic of fuel cell. Then battery compensates high frequency fluctuation and fuel cell provides consistent power at steady state. To achieve this objective, most control strategies require a centralized controller, which encounter reliability and scalability issues. This paper proposes a virtual capacitor droop controller to achieve autonomous dynamic power sharing at distributed level. An autonomous dc microgrid is designed to verify the proposed method. Considering the high penetration of constant power loads (CPLs) in dc microgrid and the destabilizing effect of CPLs, system stability is investigated with the implementation of the proposed controller. Both simulation and hardware experiment are conducted to validate the effectiveness of the proposed control method and analytical results.Keywords
This publication has 17 references indexed in Scilit:
- Hierarchical Control for Multiple DC-Microgrids ClustersIEEE Transactions on Energy Conversion, 2014
- A Novel Droop-Based Average Voltage Sharing Control Strategy for DC MicrogridsIEEE Transactions on Smart Grid, 2014
- Distributed Adaptive Droop Control for DC Distribution SystemsIEEE Transactions on Energy Conversion, 2014
- Virtual impedance based stability improvement for DC microgrids with constant power loads2014
- Frequency-Coordinating Virtual Impedance for Autonomous Power Management of DC MicrogridIEEE Transactions on Power Electronics, 2014
- Supervisory Control of an Adaptive-Droop Regulated DC Microgrid With Battery Management CapabilityIEEE Transactions on Power Electronics, 2014
- Mode-Adaptive Decentralized Control for Renewable DC Microgrid With Enhanced Reliability and FlexibilityIEEE Transactions on Power Electronics, 2013
- An Interconnection and Damping Assignment Passivity-Based Controller for a DC–DC Boost Converter With a Constant Power LoadIEEE Transactions on Industry Applications, 2013
- Distributed Control to Ensure Proportional Load Sharing and Improve Voltage Regulation in Low-Voltage DC MicrogridsIEEE Transactions on Power Electronics, 2012
- Constant Power Loads and Negative Impedance Instability in Automotive Systems: Definition, Modeling, Stability, and Control of Power Electronic Converters and Motor DrivesIEEE Transactions on Vehicular Technology, 2006