Shear Capacity of Hybrid Plate Girders
Authors:
- 1 September 2007
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 12 (5) , 535-543
Abstract
The AASHTO LRFD Bridge Design Specifications, in versions up to and including the 2003 interim, limit the shear resistance of hybrid steel I-girders to the shear buckling or shear yield load and prevent consideration of the additional capacity due to tension field action, which homogeneous girders are allowed to include. This limitation severely affected the economy of girders utilizing high-performance steel, whose optimum configuration is often hybrid. Therefore, an experimental investigation was initiated by the National Bridge Research Organization at the University of Nebraska-Lincoln to address the limitation on the consideration of tension field action in hybrid girders. This paper presents the findings of that research. Eight simply supported steel I-girders were designed, constructed, and loaded to failure to investigate their failure mechanisms and shear capacities. All girders tested were capable of supporting loads greater than those predicted, considering full contribution from tension field ...Keywords
This publication has 5 references indexed in Scilit:
- Tension Field Action in Hybrid Steel GirdersEngineering Journal, 2002
- High-Performance Steel Cost Comparison StudyTransportation Research Record: Journal of the Transportation Research Board, 2002
- Shear buckling coefficients of plate girder web panelsComputers & Structures, 1996
- Strength of Plate Girders Under Combined Bending and ShearJournal of the Structural Division, 1961
- Strength of Plate Girders in ShearJournal of the Structural Division, 1961