Fabrication of submicrometer MOSFET's using gas immersion laser doping (GILD)
Authors:
- K. BezjianKBK. Bezjian
- T.W. SigmonTST.W. Sigmon
- P. GildeaPGP. Gildea
- T.J. MageeTMT.J. Magee
- 1 July 1986
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 7 (7) , 440-442
Abstract
The fabrication of MOSFET's with submicrometer gate lengths using Gas Immersion Laser Doping (GILD) to dope the source-drain and gate regions of n-channel devices is described. The GILD step relies on a melt/regrowth process, initiated by a pulsed excimer laser (XeCl, λ = 308 nm), to drive in a dopant species adsorbed on the clean silicon surface. High dopant concentrations (1 × 1019to 2 × 1021cm-3) and shallow junctions (600-1000 Å) make this process ideally suited for source-drain formation in submicrometer structures. In this work the transistors are fabricated using an otherwise conventional NMOS process. The resultant devices have similar source-drain Rsheetvalues and lower poly Rsheetwhen compared to devices fabricated using a conventional implanted source-drain and diffused polysilicon gate. Short-channel devices (L_{poly} = 0.9µm) exhibit excellent I-V characteristics and little change in Vt.Keywords
This publication has 4 references indexed in Scilit:
- Ultra-shallow high-concentration boron profiles for CMOS processingIEEE Electron Device Letters, 1985
- Electrical properties of implanted and rapid thermal annealed shallow p+-n junctionsApplied Physics Letters, 1984
- VLSI Process modeling—SUPREM IIIIEEE Transactions on Electron Devices, 1983
- Chemical Etching1978