Design and Fabrication of 3-D-Printed High-Gain Broadband Fresnel Zone Lens Using Hybrid Groove-Perforation Method for Millimeter-Wave Applications
Open Access
- 1 October 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 21 (1) , 34-38
Abstract
This letter presents a novel hybrid design approach for the Fresnel zone lenses (FZL). The method combines the two conventional design approaches: grooved and perforated methods. Perforated lenses minimize the shadow blockage that grooved lenses suffer from, and therefore provide improved antenna gain. However, the fabrication of the low refractive index regions in the perforated lenses is challenging due to the limited manufacturing resolution, which means low refractive index dielectrics cannot be realized. The proposed hybrid FZL design utilizes the perforated method for the inner regions and applies the grooved method for the outer regions. This letter describes the equations used to optimize the design and gives the general design guidelines. A hybrid FZL antenna that operates at the center frequency of 33 GHz is presented. Measurement results show that the hybrid FZL improved the realized gain by up to 3.2 dB and the –3 dB gain bandwidth by up to 2 GHz when compared with the equivalent grooved FZL.Keywords
Funding Information
- U.K. EPSRC Grand Challenge SYMETA (EP/N010493/1)
- EPSRC ANISAT (EP/S030301/1)
This publication has 18 references indexed in Scilit:
- 3D‐printed planar graded index lensesIET Microwaves, Antennas & Propagation, 2016
- Design and fabrication of 3D‐printed planar Fresnel zone plate lensElectronics Letters, 2016
- Millimeter-Wave Conical Fresnel Zone Lens of Flat Dielectric RingsIEEE Transactions on Antennas and Propagation, 2014
- Design Equation for Multidielectric Fresnel Zone Plate LensIEEE Microwave and Wireless Components Letters, 2012
- Performance of Hemielliptic Dielectric Lens Antennas With Optimal Edge IlluminationIEEE Transactions on Antennas and Propagation, 2009
- Shadow blockage improvement using a perforated dielectric Fresnel lens2004
- Design and performance of a perforated dielectric Fresnel lensIEE Proceedings - Microwaves, Antennas and Propagation, 2003
- Shadow blockage effects on the aperture efficiency of dielectric Fresnel lensesIEE Proceedings - Microwaves, Antennas and Propagation, 2000
- Millimeter-wave Fresnel-zone plate lens and antennaIEEE Transactions on Microwave Theory and Techniques, 1995
- Millimeter-Wave Characteristics of Phase-Correcting Fresnel Zone PlatesIEEE Transactions on Microwave Theory and Techniques, 1987