Identification of capacitor position in a radial system
Authors:
- D. NieburDND. Niebur
- C.O. NwankpaCNC.O. Nwankpa
- R. FischlRFR. Fischl
- D. RichardsonDRD. Richardson
- 1 October 1999
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 14 (4) , 1368-1373
Abstract
As modern equipment is more sensitive to power quality phenomena, transients introduced by capacitor switching become an increasing concern. The paper addresses the identification of switched capacitor position such that on-line or post-fault measures can be taken. The position is given in terms of proportional line impedance seen from the load bus. Perturbation methods are used to find an asymptotic expression for capacitor position as a function of the transient frequency. This paper presents analytical and simulation results for a standard radial distribution system.Keywords
This publication has 5 references indexed in Scilit:
- Application of distribution system capacitor banks and their impact on power qualityIEEE Transactions on Industry Applications, 1996
- Introduction to Perturbation Methods1995
- Characteristics and Measurements of Capacitor Switching at Medium Voltage Distribution LevelIEEE Transactions on Industry Applications, 1994
- Minimal transient switching of capacitorsIEEE Transactions on Power Delivery, 1993
- Overcurrent protection of capacitors applied on industrial distribution systemsIEEE Transactions on Industry Applications, 1993