Prediction of Power Losses Due to Tooth Friction in Gears
Authors:
- 1 July 2006
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 49 (2) , 260-270
Abstract
Sliding friction between gear teeth is recognized as one of the main sources of power loss in geared transmissions as well as a potential source of vibration and noise. Its accurate modeling is therefore of primary importance in efficiency and vibration analyses of mechanical transmissions. For lubricated contacts, various empirical friction laws based on results from simulators can be found in the literature. One of their limitations comes from the specimen surface texture, which is often different to that of actual gears. Moreover, most of these models were established for high slide-to-roll ratios and cannot be used for low slide-to-roll ratios as encountered near the pitch point in gears. In this article, friction measurements were derived from an EHL simulator with contact conditions and surface finish close to those in gears and which covers a wide range of sliding/rolling conditions. A new traction law is proposed and integrated in a three-dimensional dynamic model of gears with consideration of tooth friction. The numerical results are then compared with the experimental evidence from a gear test rig. It is observed that tooth friction can strongly affect dynamic transmissibility through bearing mounts. Finally, the need of an accurate friction model for reliable power loss predictions is stressed.Keywords
This publication has 9 references indexed in Scilit:
- Static and Dynamic Tooth Loading in Spur and Helical Geared Systems-Experiments and Model ValidationJournal of Mechanical Design, 2002
- Experimental and Numerical Investigations on the Influence of Tooth Friction in Spur and Helical Gear DynamicsJournal of Mechanical Design, 2000
- Effect of Surface Finish on Gear Tooth FrictionJournal of Tribology, 1999
- Viscoelastic Effects in MIL-L-7808-Type Lubricant, Part I: Analytical FormulationTribology Transactions, 1992
- Effect of Geometry and Operating Conditions on Spur Gear System Power LossJournal of Mechanical Design, 1981
- Shear behaviour of elastohydrodynamic oil filmsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1977
- Thermal contact conductance; theoretical considerationsInternational Journal of Heat and Mass Transfer, 1974
- Instantaneous Coefficients of Gear Tooth FrictionA S L E Transactions, 1961
- On the action of a locomotive driving wheelProceedings of the Royal Society of London. Series A, Containing Papers of a Mathematical and Physical Character, 1926