Cabling Constraints in PV Array Architecture: Design, Mathematical Model and Cost Analysis
Authors:
- Fahad Usman KhanFKFahad Usman Khan
- Ali Faisal MurtazaAMAli Faisal Murtaza
- Hadeed Ahmed SherHSHadeed Ahmed Sher
- Kamal Al-HaddadKamal Al-Haddad
- Faisal MustafaFMFaisal Mustafa
- 6 October 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 182742-182754
Abstract
In this article, cabling constraints of different photovoltaic (PV) configurations is addressed in three steps: 1) a cable selection criterion is developed in accordance with metric system defined by American Wire Gauge (AWG); 2) a mathematical model is designed, which estimates the cable length for any array size; and 3) cost functions are devised owing to estimate the cables capital expenditure. The aforementioned steps are developed for Series (S), Parallel (P), Series-Parallel (SP), Total-cross-tied (TCT), Bridge-Link (BL) and Honey-Comb (HC). A comprehensive mathematical model is developed for each of the above mentioned architectures in the context of cabling cost versus energy payback time. This cost analysis provides a clear snapshot to the designers of PV plant about the capital investments of cabling system of specific architecture and its potential energy payback time. At the end, a design example for each configuration is presented against an array size of 10 × 2 PV panels.Keywords
This publication has 15 references indexed in Scilit:
- Modeling, simulation and performance analysis of solar PV array configurations (Series, Series–Parallel and Honey-Comb) to extract maximum power under Partial Shading ConditionsEnergy Reports, 2018
- Analysis and comparison of different PV array configurations under partial shading conditionsSolar Energy, 2018
- An Analysis of the Cost and Performance of Photovoltaic Systems as a Function of Module Area2017
- A Comprehensive Review of Catastrophic Faults in PV Arrays: Types, Detection, and Mitigation TechniquesIEEE Journal of Photovoltaics, 2015
- Modification to Wiring and Protection Standards of Photovoltaic SystemsIEEE Journal of Photovoltaics, 2014
- Maximum Power from PV Arrays Using a Fixed Configuration Under Different Shading ConditionsIEEE Journal of Photovoltaics, 2014
- Reassessment of the Limiting Efficiency for Crystalline Silicon Solar CellsIEEE Journal of Photovoltaics, 2013
- Minimization of Electrical Losses in Two-Axis Tracking PV SystemsIEEE Transactions on Power Delivery, 2013
- A Comprehensive Review and Analysis of Solar Photovoltaic Array Configurations under Partial Shaded ConditionsInternational Journal of Photoenergy, 2012
- Electrical PV Array Reconfiguration Strategy for Energy Extraction Improvement in Grid-Connected PV SystemsIEEE Transactions on Industrial Electronics, 2009