Modification of Properties of Yttria Stabilized Zirconia Epitaxial Thin Films by Excimer Laser Annealing
- 4 December 2014
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 6 (24) , 22316-22325
Abstract
This study focuses on the ultrafast improvement of surface wettability, electrical, and room temperature magnetic characteristics of cubic zirconia single crystalline thin films after laser annealing. The point defects generated by the laser treatment are envisaged to play a critical role in altering the above properties. Yttria stabilized zirconia (YSZ) thin films were epitaxially grown on Si(100) substrates by pulsed laser deposition technique and subsequently annealed by a KrF excimer laser beam (τ = 25 ns) using low-energy laser pulses. An atomically sharp interface, parallel to the film free surface, between laser annealed layer and the pristine region was observed. The single crystalline nature of thin films was preserved following the laser treatment. The laser–solid interaction with YSZ led to the introduction of point defects, i.e., oxygen vacancies, resulting in a strained structure which, in turn, resulted in the formation of a tetragonal-like zirconia. With the increase of number of laser pulses the laser treated films got highly disordered due to the high concentration of the point defects, while maintaining their crystalline nature. Although the surface of the pristine sample showed weak hydrophilic characteristics (contact angle ∼ 73°), the laser annealed samples exhibited significantly improved hydrophilic characteristics. It was found that there is an optimum number of laser pulses where the maximum hydrophilicity (contact angle ∼ 22°) is obtained. The carrier concentration in the sample with the highest hydrophilicity was determined to be higher by about 5 orders of magnitude compared to the pristine sample. This sample possessed the lowest electrical resistivity. The laser annealed YSZ epilayers showed a superior room-temperature ferromagnetic behavior, compared to the pristine samples. A 2-fold enhancement in the magnetization of the samples was observed following the laser treatment which is a clear demonstration of the key role of defects and their transient distribution throughout the lattice. All these observations were correlated with the formation of point defects due to the photon interaction with YSZ and absorption of energy of the KrF laser photons to produce defects.Keywords
Funding Information
- National Science Foundation (EEC 1156762)
This publication has 58 references indexed in Scilit:
- Enhancement of electrical characteristics and reliability in crystallized ZrO2 gate dielectrics treated with in-situ atomic layer doping of nitrogenApplied Surface Science, 2014
- UV Photon-Induced Water Decomposition on Zirconia NanoparticlesThe Journal of Physical Chemistry C, 2014
- Effect of Nanospinel Additions on the Sintering of Magnesia–Zirconia Ceramic CompositesACS Applied Materials & Interfaces, 2014
- Impact of Gd2O3 passivation layer on interfacial and electrical properties of atomic-layer-deposited ZrO2 gate dielectric on GaAsApplied Surface Science, 2014
- Insight into the Aging Effect on Enhancement of Hydrogen-Sensing Characteristics of a Zirconia-Based Sensor Utilizing a Zn–Ta–O-Based Sensing ElectrodeACS Applied Materials & Interfaces, 2013
- Sustainable Flow Oppenauer Oxidation of Secondary Benzylic Alcohols with a Heterogeneous Zirconia CatalystOrganic Letters, 2013
- Role of a Functionalized Polymer (K2621) and an Inorganic Material (Sulphated Zirconia) as Supports in Hydrogen Peroxide Direct Synthesis in a Continuous ReactorIndustrial & Engineering Chemistry Research, 2013
- Glycerol Hydrogenolysis to Propylene Glycol and Ethylene Glycol on Zirconia Supported Noble Metal CatalystsACS Catalysis, 2013
- Mesoporous Zirconia Thin Films with Three-Dimensional Pore Structures and Their Application to Electrochemical Glucose DetectionACS Applied Materials & Interfaces, 2013
- Master sintering curves of a nanoscale 3Y-TZP powder compactsCeramics International, 2009