Mechanisms of Chemical-Mechanical Polishing of SiO2Dielectric on Integrated Circuits
Authors:
- 1 January 1998
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 41 (4) , 593-599
Abstract
One of the fundamental mechanisms of chemical-Mechanical polishing (CMP) is the mechanical interaction between the wafer and polishing pad. This interaction was simulated in experiments. The vertical displacement of the wafer with respect to the polishing pad, the fictional drag of the wafer against the pad, and the pressure of the slurry trapped between the wafer and pad were measured. These experiments were performed over a range of commercially common CMP conditions. In addition, polishing rates were measured for CMP performed under induced hydrodynamic conditions where the wafer was separated from the pad by a film of slurry. It was found that no appreciable polishing occurred under hydrodynamic CMP conditions. Under commercial CMP conditions, it was found that the wafer contacts the polishing pad asperities as evidenced by near-zero wafer displacement and high friction coefficients (˜0.4). It was also found that pad conditioning (intentional roughening) causes a suction force to develop between the wafer and pad. This suction force draws the wafer into further contact with the pad, by as much as 20 μm, and corresponds to peak slurry vacuum pressures of 12 kPa (1.7 psi).Keywords
This publication has 3 references indexed in Scilit:
- Chemical‐Mechanical Polishing in Semidirect Contact ModeJournal of the Electrochemical Society, 1995
- Feature‐Scale Fluid‐Based Erosion Modeling for Chemical‐Mechanical PolishingJournal of the Electrochemical Society, 1994
- The Evolution of Chem-Mechanical Planarization: From Aberrant to ProsaicMRS Proceedings, 1994