Impact of aliphatic amine comonomers on DGEBA epoxy network properties
- 2 October 2013
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 54 (9) , 2132-2138
Abstract
This study characterized the mechanical and thermal properties of the oligomer‐based formulations of the diglycidyl ether of bisphenol A (DGEBA) cured with series aliphatic amines (triethylenetetramine (TETA), tetraethylenepentamine (TEPA) and O,O bis (2‐aminopropyl propylene glycol) (Jeffamine D230) with different functionalities in the glassy state. Impact Izod and three‐point bending tests were conducted to determine the networks' impact energy ( E i ), elasticity modulus ( E y ), yield stress ( σ y ) and fracture toughness ( K IC ) values. The same three‐point bending mode was also employed to characterize the systems' thermo‐mechanical properties (DMA) and storage modulus ( E ') and damping modulus (tan δ = E "/ E ') values. The DGEBA/D230 network showed greater flexibility, maximum impact energy, higher fracture toughness, and a lower yield stress than the DGEBA/TETA and DGEBA/TEPA networks. The fracture behavior of these epoxy systems was correlated to the molecular weight between the crosslink points, M c , and the plastic zone size ( r p ) at the crack tip carved in the samples. The DGEBA/D230 network had the highest storage modulus and tan δ intensity, together with higher toughness and deformation during the network's fracture. These results were a consequence of the structural characteristics of comonomers, including their chain segment flexibility, molecular weight between crosslink points and functionality. POLYM. ENG. SCI., 54:2132–2138, 2014. © 2013 Society of Plastics EngineersKeywords
Funding Information
- Conselho Nacional de Desenvolvimento Cient�fico e Tecnol�gico (CNPq)
This publication has 28 references indexed in Scilit:
- Master curve and time–temperature–transformation cure diagram of a polyfunctional epoxy acrylic resinJournal of Applied Polymer Science, 2010
- Curing kinetics study of epoxy resin/flexible amine toughness systems by dynamic and isothermal DSCThermochimica Acta, 2008
- Mechanical properties of epoxy networks based on DGEBA and aliphatic aminesJournal of Applied Polymer Science, 2007
- The effect of particle–matrix adhesion on the mechanical behavior of glass filled epoxies. Part 2. A study on fracture toughnessPolymer, 2003
- Brittle to ductile: Fracture toughness mapping on controlled epoxy networksPolymer Engineering & Science, 1999
- Dynamic and mechanical properties of epoxy networks obtained with PPO based amines/mPDA mixed curing agentsPolymer, 1996
- Mechanical and viscoelastic properties of epoxy networks cured with aromatic diaminesPolymer, 1991
- Epoxy networks based on dicyandiamide: effect of the cure cycle on viscoelastic and mechanical propertiesPolymer, 1990
- Review of the microscopic and macroscopic aspects of fracture of unmodified and modified epoxy resinsMaterials Science and Engineering: A, 1990
- Packing density of nonstoichiometric epoxide‐amine networksJournal of Applied Polymer Science, 1987