Investigation of the Wear Progression of Nozzle in Abrasive Waterjet Machining with Different Abrasive Material
Open Access
- 25 April 2025
- journal article
- Published by Jan Evangelista Purkyne University in Usti nad Labem in Manufacturing Technology
- Vol. 25 (1) , 76-85
Abstract
Determining the productivity and quality of precision AWJ machining requires routine and careful inspection of nozzle condition. The degradation of the inner bore of the nozzle adversely impacts the mixing efficiency and uniformity of the water jet, thereby affecting its cutting performance. In this study, new nozzle was designed and manufactured using additive manufacturing and were made of 316 L stainless steel. The new nozzle consists of two combined parts with the peculiarity of being easy to install using a screw thread. The wear behaviour of the new nozzle was examined using an accelerated wear test. An accelerated wear test was conducted on the hard abrasive silicon carbide (SiC) and compared to garnet, the abrasive commonly used in the AWJ industry. The aim of the test was to determine the wear pattern of the nozzle. The cumulative mass loss and nozzle diameter increase for different abrasives were measured. The geometric change in the nozzle is made visible through destructive examination. The findings indicated that the type of abrasives significantly affects nozzle wear. As the hardness of the abrasive increases, the diameter of the nozzle enlarges, resulting in accelerated nozzle wear. The mass loss factor of SiC abrasives is three times higher than that of garnet abrasives. This research allows practitioners to monitor the nozzle wear behaviour during the AWJ process. The results obtained were used to estimate the nozzle life based on the observed wear history.Keywords
This publication has 21 references indexed in Scilit:
- Feasible study on the sustainable and clean application of steel slag for abrasive waterjet machiningJournal of Cleaner Production, 2023
- Tribology in (abrasive) water jet machining: A review2022
- Developments in abrasive water jet machining process—from 1980 to 20202021
- Abrasive water jet drilling of float glass and characterization of hole profileGlass Structures & Engineering, 2019
- A study of wear on focusing tubes exposed to corundum-based abrasives in the waterjet cutting processThe International Journal of Advanced Manufacturing Technology, 2019
- Impact of Nozzle Design on Surface Roughness of Abrasive Jet Machined Glass Fibre Reinforced Polymer CompositesSilicon, 2018
- Developing New Design and Investigating Porous Nozzles for Abrasive Jet MachinePowder Metallurgy and Metal Ceramics, 2015
- The effect of particle hardness and shape when abrasive water jet milling titanium alloy Ti6Al4VWear, 2009
- Performance of different abrasive materials during abrasive water jet machining of glassJournal of Materials Processing Technology, 2007
- The effects of system and geometric parameters on abrasive water jet nozzle wearInternational Journal of Machine Tools and Manufacture, 2002