Characterization of Porous Phosphate Coatings Enriched with Magnesium or Zinc on CP Titanium Grade 2 under DC Plasma Electrolytic Oxidation
Open Access
Abstract
The aim of the paper is to study and determine the effect of voltage increasing from 500 up to 650 VDC on chemical and electrochemical properties of the obtained porous coatings with plasma electrolytic oxidation (PEO) processes, known also as micro arc oxidation (MAO). In the present paper, the chemical and electrochemical characterization of porous phosphate coatings enriched with magnesium or zinc on commercially pure (CP) Titanium Grade 2 under DC-PEO obtained in electrolytes based on concentrated 85% analytically pure H3PO4 (98 g/mole) acid with additions of 500 g·L−1 of zinc nitrate Zn(NO3)2∙6H2O or magnesium nitrate Mg(NO3)2∙6H2O, are described. These materials were characterized using scanning electron microscope (SEM) with energy-dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS) and glow discharge optical emission spectroscopy (GDOES). It was found that the voltage of PEO process has influence on the chemical composition and thickness of the obtained porous coatings as well as on their electrochemical behavior. The higher the potential of PEO treatment, the higher the amount of zinc-to-phosphorus ratio for zinc enriched coatings was obtained, whereas in magnesium enriched coatings, the average amount of magnesium detected in PEO coating is approximately independent of the PEO voltages. Based on XPS studies, it was found out that most likely the top 10 nm of porous coatings is constructed of titanium (Ti4+), magnesium (Mg2+), zinc (Zn2+), and phosphates PO43− and/or HPO42− and/or H2PO4− and/or P2O74−. On the basis of GDOES studies, a four-sub-layer model of PEO coatings is proposed. Analysis of the potentiodynamic corrosion curves allowed to conclude that the best electrochemical repeatability was noted for magnesium and zinc enriched coatings obtained at 575 VDC.Keywords
This publication has 46 references indexed in Scilit:
- A Proposal for Simplifying the Method of Evaluation of Uncertainties in Measurement ResultsMeasurement Science Review, 2013
- Characterization of Passive Film Formed on AISI 316L Stainless Steel after Magnetoelectropolishing in a Broad Range of Polarization ParametersSteel Research International, 2012
- Characterization of passive films formed on titanium during anodic oxidationElectrochimica Acta, 2011
- Investigation of selected surface properties of AISI 316L SS after magnetoelectropolishingMaterials Chemistry and Physics, 2010
- Co–Cr alloy corrosion behaviour after electropolishing and “magnetoelectropolishing” treatmentsMaterials Letters, 2008
- Dependence of growth features of microarc oxidation coatings of titanium alloy on control modes of alternate pulseMaterials Letters, 2004
- Initial stages of plasma electrolytic oxidation of titaniumCorrosion Science, 2003
- Synthesis of nanocrystalline titania films by micro-arc oxidationMaterials Letters, 2002
- Concept of microsmoothing in the electropolishing processSurface and Coatings Technology, 1994
- On the Solution of Equations of Diffusion Presented in Their Paper “Diffusion and Solid‐Film Formation during Electropolishing of Metals”Journal of the Electrochemical Society, 1989