Texture‐Induced Anisotropy in Asymmetrically Rolled Aluminium Alloys
- 2 May 2011
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 13 (10) , 949-954
Abstract
The formability of Al alloys is strongly correlated to the crystallographic texture and thus can be controlled by thermomechanical processing parameters. Texture‐induced anisotropy is studied in asymmetrically hot and cold rolled Al alloys from the 6xxx series. It is found that the strain mode of both hot and cold rolling processes significantly affects the anisotropy of recrystallized material. The recrystallization textures produced in the ASR process improve the normal anisotropy, whereas the in‐plane anisotropy does not benefit significantly from the ASR process. Results of crystal plasticity calculations show that an improved normal anisotropy in asymmetrically rolled sheets (${\bar {r}}$ = 0.77) ensures an increased limiting drawing ratio of ≈ 2.11, which is beneficial for formability.Keywords
This publication has 13 references indexed in Scilit:
- Analysis of microstructure and texture evolution in pure magnesium during symmetric and asymmetric rollingActa Materialia, 2009
- Development of severe plastic deformation by various asymmetric rolling processesMaterials Science and Engineering: A, 2009
- Controlling the plastic anisotropy in asymmetrically rolled aluminium sheetsPhilosophical Magazine, 2008
- Microstructural and crystallographic aspects of conventional and asymmetric rolling processesActa Materialia, 2008
- Evolution of texture in AA6111 aluminum alloy after asymmetric rolling with various velocity ratios between top and bottom rollsMaterials Science and Engineering: A, 2007
- Crystallographic texture evolution of continuous cast Al–Mn–Mg alloy sheet during cold rolling and annealingMaterials Science and Engineering: A, 2007
- Texture control by thermomechanical processing of AA6xxx Al–Mg–Si sheet alloys for automotive applications—a reviewMaterials Science and Engineering: A, 2002
- Analysis of deformation textures of asymmetrically rolled aluminum sheetsActa Materialia, 2001
- Effect of intermediate annealing on texture evolution and plastic anisotropy in an Al-Mg autobody alloyMetallurgical and Materials Transactions A, 2000
- A self-consistent anisotropic approach for the simulation of plastic deformation and texture development of polycrystals: Application to zirconium alloysActa Metallurgica et Materialia, 1993