Investigation on Microstructure and Dry Sliding Wear Behavior of a Novel Fe-Cr-B-C-Al-Si-Mn Composite Coatings on 2Cr13 Steel by Laser Cladding
- 18 October 2021
- journal article
- research article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 31 (3) , 2381-2390
Abstract
No abstract availableKeywords
This publication has 41 references indexed in Scilit:
- First-principle calculations of structural, elastic and thermodynamic properties of Fe–B compoundsIntermetallics, 2014
- The in-flight temperature variation and dissolution of WC powder particles producing an Fe–Cr–W–C system by direct laser depositionSurface and Coatings Technology, 2012
- Aging of a cast 35Cr–45Ni heat resistant alloyMaterials Chemistry and Physics, 2012
- Microstructure of high (45wt.%) chromium cast irons and their resistances to wear and corrosionWear, 2011
- The abrasive wear resistance of TIC and (Ti,W)C-reinforced Fe–17Mn austenitic steel matrix compositesTribology International, 2010
- Microstructure and tribological characteristics of nitrided layer on 2Cr13 steel in air and vacuumSurface and Coatings Technology, 2009
- Microstructure, mechanical and wear properties of TiC particulate reinforced 2Cr13 steel byin situreaction and electroslag remeltingIronmaking & Steelmaking: Processes, Products and Applications, 2008
- Effect of carbon content on the microstructure and the cracking susceptibility of Fe-based laser-clad layerApplied Surface Science, 2005
- Magnetron sputtering: a review of recent developments and applicationsVacuum, 2000
- The precipitation characteristics of 20% Cr/25% NiNb stabilised stainless steelActa Metallurgica, 1988