Characterization of Turn-On Time Delay in a Fiber Grating Fabry–Perot Lasers
Open Access
- 20 August 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 4 (5) , 1662-1678
Abstract
In this paper, turn-on time delay characteristics of a fiber grating Fabry-Perot (FGFP) laser are numerically investigated by considering all the carrier recombination rate (CRR) R(N) coefficients (nonradiative, Anr; radiative, B; and Auger coefficient, C). The results show that the turn-on time delay significantly reduces by increasing the injection current (Iinj) and/or the initial value of carrier density (Ni). Meanwhile, the turn-on time delay increases by increasing the CRR coefficients. However, its effect can be minimized by increasing Iinj and/or Ni. In addition, the turn-on time delay can be reduced by increasing the external optical feedback (OFB) level. Moreover, it is shown that the optimum external-cavity length (Lext) is 3.1 cm. Furthermore, an antireflection (AR) coating reflectivity value of 1 × 10-2 is sufficient for the laser to operate at good turn-on time delay and low fabrication complexity. The obtained results can provide an important idea for the practical fabrication of the FGFP laser used in the dense wavelength-division multiplexing (DWDM) systems and optical access networks.Keywords
This publication has 59 references indexed in Scilit:
- Characterization of small-signal intensity modulation of single-mode fiber grating Fabry-Perot laser sourceOptical Review, 2012
- Numerical analysis of optical bistability based on Fiber Bragg Grating cavity containing a high nonlinearity doped-fiberOptics Communications, 2012
- Experimental characterization of DFB and FP chaotic lasers with strong incoherent optical feedbackOptics & Laser Technology, 2011
- Theoretical calculation of turn-on delay time of VCSEL and effect of carriers recombinationOptics & Laser Technology, 2007
- Laser driver with subthreshold laser bias and turn-on-delay compensation by prejittering of the modulating currentAEU - International Journal of Electronics and Communications, 2006
- Shaping current waveforms for direct modulation of semiconductor lasersIEEE Journal of Quantum Electronics, 2004
- Effect of the turn-on delay of a semiconductor laser on clipping impulsive noiseIEEE Photonics Technology Letters, 1997
- The frequency dependence of clipping induced bit-error rates in subcarrier multiplexed systemsIEEE Photonics Technology Letters, 1996
- Wavelength stable uncooled fibre grating semiconductorlaser for use in an alloptical WDM access networkElectronics Letters, 1996
- Laser turn-on delay and chirp noise effects in Gb/s intensity-modulated direct-detection systemsJournal of Lightwave Technology, 1995