A fully superconducting magnetic bearing with a jointless coil excited by a superconducting dynamo
Open Access
- 9 August 2024
- journal article
- research article
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 37 (9) , 095021
Abstract
Superconducting magnetic bearings usually combine a setup of permanent magnets (PMs) and superconducting bulks. The bearing size is typically scaled up to increase the levitation force as the force density is limited in such setups due to the magnetic flux density and its spatial gradient. As alternative, the PMs might be replaced by a superconducting coil. To test this, jointless coils were prepared by a wind and flip technology using coated conductors of different tape manufacturers. The realized pancake coils were studied at liquid nitrogen temperature. Numerical simulations yielded a magnetic field of up to 0.5 T at 77 K for coils with a inner diameter of 20 mm. The prepared coils were charged with a superconducting dynamo, in which two magnet configurations were tested. A clear dependence on the magnet size and frequency was found for the charging characteristics. A magnetic field of about 0.3 T at 77 K was imprinted in one of the coils. However, a degradation of the coils was found over time indicated by some delamination at the cutted edges, which reduced the maximum achievable magnetic field after a few weeks. Nevertheless, a fully superconducting bearing was realized with by combining the jointless coil with an additional YBCO bulk. After charging the coil with the dynamo, a levitation force of up to 10 N at 77 K was measured under zero-field cooling conditions. The generated levitation force decayed only slightly after charging indicating low losses in the coil.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (452135712)
This publication has 45 references indexed in Scilit:
- Origin of the DC output voltage from a high-Tc superconducting dynamoApplied Physics Letters, 2019
- Voltage-ampere characteristics of YBCO coated conductor under inhomogeneous oscillating magnetic fieldApplied Physics Letters, 2016
- Anomalous open-circuit voltage from a high-Tc superconducting dynamoApplied Physics Letters, 2016
- Origin of dc voltage in type II superconducting flux pumps: field, field rate of change, and current density dependence of resistivityJournal of Physics D: Applied Physics, 2016
- Magnetic Properties of the Stack of HTSC Tapes in a Wide Temperature RangePhysics Procedia, 2015
- Structural parameter optimization design for Halbach permanent maglev railPhysica C: Superconductivity and its Applications, 2010
- Temperature dependence of levitation force and its relaxation in a HTS levitation systemPhysica C: Superconductivity and its Applications, 2010
- Lateral-displacement influence on the levitation force in a superconducting system with translational symmetryApplied Physics Letters, 2008
- Design and fabrication of permanent mode magnet by using coated conductorPhysica C: Superconductivity and its Applications, 2006
- Influence of the lateral movement on the levitation and guidance force in the high-temperature superconductor maglev systemApplied Physics Letters, 2005