Capacitive transducer for in‐mold monitoring of injection molding
- 16 August 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (8) , 1571-1578
Abstract
A capacitive transducer is developed for online monitoring of the in‐mold material status for injection molding, particularly for measurements of melt‐front position and flow‐rate. This paper will show, in addition to fulfilling its design purposes, that such a sensor can also be effectively used for the detection of the start and end of mold filling, the time of gate freezing, and over‐packing. Polym. Eng. Sci. 44:1571–1578, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 12 references indexed in Scilit:
- Visualization of Injection MoldingJournal of Reinforced Plastics and Composites, 1998
- Fluorescence monitoring of polymer injection molding: Model developmentPolymer Engineering & Science, 1997
- On‐line ultrasonic monitoring of the injection molding processPolymer Engineering & Science, 1997
- Cavity pressure dynamics and self‐tuning control for filling and packing phases of thermoplastics injection moldingPolymer Engineering & Science, 1996
- Capacitive sensors: When and how to use themSensors and Actuators A: Physical, 1993
- Dynamics and Control of Surface and Mold Temperatures in Injection MoldingInternational Polymer Processing, 1993
- A solid-state relative humidity measurement systemIEEE Transactions on Instrumentation and Measurement, 1990
- A study of a capacitance-type position sensor for automotive useSensors and Actuators A: Physical, 1990
- Microstructural effects in capacitive composition measurementsIEEE Transactions on Instrumentation and Measurement, 1990
- Application of capacitance techniques in sensor designJournal of Physics E: Scientific Instruments, 1986