3D finite element analysis of Al7075-T6 drilling with coated solid tooling
Open Access
- 14 August 2020
- journal article
- research article
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 318, 01038
Abstract
Due to the fact that simulation of drilling was added in commercial finite element analysis (FEA) software only recently, 3D finite element modelling is an invaluable asset during related researches. The present study employs 3D FEA to model the drilling process of Al7075-T6 alloy with solid carbide tooling, investigates important phenomena that occur during drilling and finally compares the simulated results with experimental data. A number of simulations were performed with DEFORM3D™ software at different cutting conditions; cutting speed of 50m/min, 100m/min, 150m/min and feed of 0.15mm/rev, 0.20mm/rev, 0.25mm/rev. The proposed model takes into consideration certain aspects like damage initiation and evolution of the material, contact interface between the drill bit and the workpiece and standard boundary conditions. Eventually, the acquired numerical data for thrust force were compared to the experimental results for the same cutting conditions and parameters. To obtain the experimental data, a series of nine drilling tests were performed. Upon validation of the numerical data, the temperature distribution on the tool tip – workpiece interface, as well as the chip morphology (shape and curling radius) were determined. Results showed a good agreement between the numerical and the experimental data. Specifically, thrust force and chip morphology exhibited an agreement of about 95% and 90% respectively, which confirms the potential of 3D FEA implementation on machining investigations.Keywords
This publication has 7 references indexed in Scilit:
- Prediction model, simulation, and experimental validation on thrust force and torque in drilling SiCp/Al6063The International Journal of Advanced Manufacturing Technology, 2019
- Evolution of 3D chip morphology and phase transformation in dry drilling Ti6Al4V alloysJournal of Manufacturing Processes, 2018
- Development of a three-dimensional finite element method simulation model to predict modified flow drilling tool performanceInternational Journal of Material Forming, 2018
- Prediction of Thrust Force and Cutting Torque in Drilling Based on the Response Surface MethodologyMachines, 2018
- 3D numerical analysis of drilling process: heat, wear, and built-up edgeAdvances in Manufacturing, 2018
- Enhancement of tool life in drilling of hardened AISI 4340 steel using 3D FEM modelingThe International Journal of Advanced Manufacturing Technology, 2017
- 3D finite element modelling of drilling process of Al7075-T6 alloy and experimental validationJournal of Mechanical Science and Technology, 2016