Analysis of visible and near infrared spectral reflectance for assessing metals in soil
- 10 September 2016
- journal article
- research article
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 188 (10) , 558
Abstract
Visible and near infrared reflectance (VNIR; 350–2500 nm) spectroscopy has greatly been used in soils, especially for studying variability in spectrally active soil components (e.g., organic carbon, clays, and Fe/Al oxides) based on their diagnostic spectral features. In recent years, this technique has also been applied to assess soil metallic ions. In this research, the feasibility of VNIR spectroscopy for determination of soil metals was investigated with two soil data sets: (i) artificially metal-spiked and (ii) in situ metal-contaminated soils. Results showed that reflectance spectra of neither metal-spiked soils with Cd, As, and Pb even at their higher concentrations of 20, 900, and 1200 mg kg−1, respectively, nor in situ metal-contaminated soils (with concentrations of 30 mg Cd, 3019 mg As, and 5725 mg Pb kg−1 soil) showed any recognized absorption peaks that correspond to soil metal concentrations. We observed variations in reflectance intensity for in situ metal-contaminated soils only, showing higher reflectance across the entire spectrum for strongly and lower for less metal-contaminated soils. A significant correlation was found between surface soil metals’ concentrations and continuum removed spectra, while soil metals were also found significantly associated with soil organic matter and total Fe. A partial least square regression with cross-validation approach produced an acceptable prediction of metals (R2 = 0.58–0.94) for both soil data sets, metal-spiked and in situ metal-contaminated soils. However, high values of root mean square error ruled out practical application of the achieved prediction models.Keywords
This publication has 55 references indexed in Scilit:
- Comment on “Potential of integrated field spectroscopy and spatial analysis for enhanced assessment of soil contamination: A prospective review” by Horta et al.Geoderma, 2016
- Reflectance measurements of soils in the laboratory: Standards and protocolsGeoderma, 2015
- Visible and near-infrared reflectance spectroscopy is of limited practical use to monitor soil contamination by heavy metalsJournal of Hazardous Materials, 2015
- Prediction of lead concentration in soil using reflectance spectroscopyEnvironmental Technology & Innovation, 2014
- CAPABILITIES OF REMOTE SENSING HYPERSPECTRAL IMAGES FOR THE DETECTION OF LEAD CONTAMINATION: A REVIEWISPRS Annals of the Photogrammetry, Remote Sensing and Spatial Information Sciences, 2012
- Near-infrared (NIR) and mid-infrared (MIR) spectroscopic techniques for assessing the amount of carbon stock in soils – Critical review and research perspectivesSoil Biology and Biochemistry, 2011
- Using Imaging Spectroscopy to study soil propertiesRemote Sensing of Environment, 2009
- Adsorption of heavy metal ions on soils and soils constituentsJournal of Colloid and Interface Science, 2004
- On-the-go soil sensors for precision agricultureComputers and Electronics in Agriculture, 2004
- Near‐Infrared Analysis as a Rapid Method to Simultaneously Evaluate Several Soil PropertiesSoil Science Society of America Journal, 1995