A 10 MHz mixed-signal CPM controlled DC-DC converter IC with novel gate swing circuit and instantaneous efficiency optimization
Authors:
- 1 September 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23293721,p. 1229-1235
Abstract
This paper introduces a mixed-signal peak current-programmed mode controlled 10 MHz dc-dc converter integrated circuit (IC) for low-power applications. The IC combines segmented power transistors, gate drivers and the main functional blocks of a multi-mode controller. Based on the information about the peak transistor current, obtained from the voltage loop, the controller instantaneously changes the number of segments, gate drive voltage, or switches to pulse-frequency modulation, such that for each operating point efficiency is optimized. To obtain reliable operation at such a high switching frequency and achieve efficiency optimization novel architecture of gate swing circuit is combined with modifications of known designs of other functional blocks. Experimental verification of a 0.6 W buck converter IC, fabricated in a 0.13 μm process, demonstrate the peak efficiency of an 83%, near time-optimal dynamic response, and up to a 20% efficiency improvement due to the action of the efficiency optimization controller.Keywords
This publication has 14 references indexed in Scilit:
- Digitally Controlled Current-Mode DC–DC Converter ICIEEE Transactions on Circuits and Systems I: Regular Papers, 2010
- Multiphase optimal response mixed-signal current-programmed mode controller2010
- Digitally controlled low-power DC-DC converter with segmented output stage and gate charge based instantaneous efficiency optimization2009
- Proximate Time-Optimal Digital Control for Synchronous Buck DC–DC ConvertersIEEE Transactions on Power Electronics, 2008
- Continuous-Time Digital Controller for High-Frequency DC-DC ConvertersIEEE Transactions on Power Electronics, 2008
- Programmable Analog-to-Digital Converter for Low-Power DC–DC SMPSIEEE Transactions on Power Electronics, 2008
- A New Digital Control Algorithm to Achieve Optimal Dynamic Performance in DC-to-DC ConvertersIEEE Transactions on Power Electronics, 2007
- Sensorless optimization of dead times in dc–dc converters with synchronous rectifiersIEEE Transactions on Power Electronics, 2006
- Improvement of Light-Load Efficiency Using Width-Switching Scheme for CMOS TransistorsIEEE Power Electronics Letters, 2005
- A 4-/spl mu/a quiescent-current dual-mode digitally controlled buck converter IC for cellular phone applicationsIEEE Journal of Solid-State Circuits, 2004