Protruding ceramic substrates for high voltage packaging of wide bandgap semiconductors
Authors:
- 1 October 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 404-410
Abstract
Wide bandgap semiconductors enable high voltage (10 kV and more) switches. As a consequence, new packaging solutions are required to prepare the ground for such devices. The metallized ceramic substrate is a well-known and established technology for voltages up to 3.3kV, but it exhibits some weaknesses at higher voltages: due to its manufacturing process, the profile of the metallization is sharp and induces a reinforcement of the electric field at the “triple point” area (where the ceramic, the conductor and the encapsulating material meet), which can lead to Partial Discharges (PD), eventually causing a failure of the module. In this paper, we present a new substrate structure, where the triple point is moved away to an area where the electric field is lower. In this structure, the ceramic is machined to form protrusions, and round-edge metallizations are brazed on top. The design of the substrate, based on finite-elements is described, and calculations show that a 1 mm-thick AlN layer should be sufficient to withstand 10 kV. The manufacturing process of this substrate is presented. The test results demonstrate the superiority of this new solution, with a partial discharge inception voltage increased by 38 %.Keywords
This publication has 7 references indexed in Scilit:
- A Survey of Wide Bandgap Power Semiconductor DevicesIEEE Transactions on Power Electronics, 2014
- Nonlinear resistive electric field control for power electronic modulesIEEE Transactions on Dielectrics and Electrical Insulation, 2012
- Partial discharge control in a power electronic module using high permittivity non-linear dielectricsIEEE Transactions on Dielectrics and Electrical Insulation, 2010
- Comparison of high voltage and high temperature performances of wide bandgap semiconductors for vertical power devicesDiamond and Related Materials, 2010
- Degradation of solid dielectrics due to internal partial discharge: some thoughts on progress made and where to go nowIEEE Transactions on Dielectrics and Electrical Insulation, 2005
- Partial Discharge Failure Analysis of AIN Substrates for IGBT ModulesMicroelectronics Reliability, 2004
- Electric field investigation in high voltage power modules using finite element simulations and partial discharge measurements2004