Effect of warm forming process parameters on 42CrMo4 skew rolled bar mechanical properties and microstructure
Open Access
- 21 March 2024
- journal article
- research article
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 24 (2) , 1-20
Abstract
Skew rolling is a manufacturing process in which two or three rolls are used to reduce the diameter or modify the shape of a cylindrical workpiece, which is used to manufacture mechanical components such as shafts, rods or balls. Hot conditions are used to overcome limitations related to material ductility, residual stress and machine capacity. In this paper, the warm skew rolling (WSR) process of 42CrMo4 rods is modeled by the finite element method. The effects of forming parameters, namely initial temperature and roll rotational velocity, on the material strain rate, thermal properties, microstructure and hardness were analyzed. Simulation results were validated by experimental process data, while hardness tests and SEM-EBSD microscopy were used to assess mechanical properties and microstructure, respectively. The WSR resulting microstructure is different from the normalized ferritic–pearlitic initial one. The degree of spheroidization (DoS) of cementite increases with temperature. The maximum DoS of 86.5% occurs at the initial temperature of 750 °C, leading to the highest material softening. Rolling from lower temperatures favors grain fragmentation and the achievement of incomplete spheroidization, which, in combination with the highest proportion of high-angle boundaries, contributes to a higher hardness of the rods with respect to those rolled at higher temperatures. The highest reduction in hardness takes place at 750 °C and 30 rpm, leading to 209.4 HV1 (30.7% reduction) and 194.1 HV1 (35.7% reduction) in the near-surface and internal regions, respectively. The driving factor is the transformation of cementite precipitates into a spheroidal form characterized by the greatest degree of dispersion.Keywords
Funding Information
- Department of Education of the Basque Government (IT1507-22)
- Central Mechanical Engineering Research Institute, Council of Scientific and Industrial Research (M/KOPM/FD-20/IM-5/013/2022)
- Universidad de Deusto
This publication has 25 references indexed in Scilit:
- Effects of process parameters on surface quality of shaft parts formed by warm cross-wedge rollingThe International Journal of Advanced Manufacturing Technology, 2021
- Microstructure and Mechanical Properties of Thermomechanically Forged Tempering Steel 42CrMo42020
- Numerical Prediction and Experimental Validation of the Microstructure of Bearing Steel Ball Formation in Warm Skew RollingMetallurgical and Materials Transactions A, 2020
- Microstructure evolution of 42CrMo4 during hot forging process of hollow shafts for wind turbinesThe International Journal of Advanced Manufacturing Technology, 2019
- Comparative study of warm and hot cross-wedge rolling:numerical simulation and experimental trialThe International Journal of Advanced Manufacturing Technology, 2017
- Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvementThe International Journal of Advanced Manufacturing Technology, 2016
- Effect of rolling speed on the occurrence of strain aging during and after warm rolling of a low-carbon steelJournal of Materials Science, 2010
- Warm forging: new forming sequence for the manufacturing of long flat piecesProduction Engineering, 2008
- Analysis of Tempering Treatment on Material Properties of DIN 41Cr4 and DIN 42CrMo4 SteelsJournal of Materials Engineering and Performance, 2007
- Effects of deformation parameters on the final microstructure and mechanical properties in warm rolling of a low-carbon steelThe International Journal of Advanced Manufacturing Technology, 2006