The effect of Ta alloying on mechanical and tribological properties of Ti-Al-N coatings
Authors:
- A. R. ShugurovASA. R. Shugurov
- 14 December 2020
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2310 (1) , 020314
Abstract
Microstructure, mechanical and tribological characteristics of Ti1–x–yAlxTayN coatings with y varied from 0 to 0.35 were studied. Wear tests were carried out at room temperature under dry friction conditions in the ball-on-disc geometry. Ta alloying was found to result in changes of the coating microstructure from V-shaped grains to columnar grains with vertical boundaries. The Ta alloyed coatings are characterized by lower hardness as compared with Ti1–xAlxN with no strong correlation between the hardness and the Ta content. In contrast, the Young's modulus exhibited overall decreasing trend with increasing y. Progressive decreasing of wear resistance of the coatings was revealed with increasing the Ta content.Keywords
This publication has 8 references indexed in Scilit:
- Tuning of mechanical properties of Ti1−xAlxN coatings through Ta alloyingSurface and Coatings Technology, 2020
- Structural-Phase State, Elastic Stress, and Functional Properties of Nanocomposite Coatings Based on Amorphous CarbonPhysical Mesomechanics, 2019
- Addition of Ta and Y in a hard Ti-Al-N PVD coating: Individual and conjugated effect on the oxidation and wear propertiesCorrosion Science, 2019
- High-temperature tribology and oxidation of Ti1−x−yAlxTayN hard coatingsSurface and Coatings Technology, 2018
- Origin of high temperature oxidation resistance of Ti–Al–Ta–N coatingsSurface and Coatings Technology, 2014
- The effect of droplets in arc evaporated TiAlTaN hard coatings on the wear behaviorSurface and Coatings Technology, 2014
- Increased thermal stability of Ti–Al–N thin films by Ta alloyingSurface and Coatings Technology, 2012
- Single layer and multilayer wear resistant coatings of (Ti,Al)N: a reviewMaterials Science and Engineering: A, 2003