Ultra-low—to high-temperature plasma-assisted nitriding: revisiting and going further on the martensitic stainless steel treatment
- 30 October 2018
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (2) , 026529
Abstract
AISI 420 steel was plasma nitrided aiming to study the relationships between treatment temperature and the treated layer phase constitution and properties. Nitriding was carried out in temperatures varying from 200 to 600 °C for 4 h treatment time. Samples were characterized by OM, XRD and hardness measurements. For treatments carried out at 200 and 250 °C (here termed 'ultra-low' temperatures), it was observed the formation of N-expanded martensite (α'N phase) only. For low-temperatures (300 to 400 °C), the treated surfaces presented α'N and epsilon-iron nitride (ε-Fe2+xN) phases. At high temperatures (450 to 600 °C), ε-Fe2+xN and increasing amount of chromium nitrides (CrN and Cr2N phases) were verified in the nitrided layers with temperature rise. From 500 °C, the occurrence of gama'-iron nitride (γ'-Fe4N) was additionally noticed. Results also indicate that nitrided layer growth follows the Arrhenius law and presents two slopes in the Arrhenius plot. The activation energy for ultra-low and low temperatures is about two times smaller than that for high temperatures, suggesting two different growth mechanisms, probably one based on high-diffusivity paths (for the lower temperatures), and the other one on volume diffusion (for the higher temperatures), with activation energy of 64 ± 16 and 119 ± 12 kJ mol−1, respectively.Keywords
Funding Information
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (482380/2012-8)
- MCTI/CNPq/CT-Aquaviário (456347/2013-5)
This publication has 78 references indexed in Scilit:
- Improvement of erosion and erosion–corrosion resistance of AISI420 stainless steel by low temperature plasma nitridingApplied Surface Science, 2008
- Improvement of corrosion and wear resistances of AISI 420 martensitic stainless steel using plasma nitriding at low temperatureSurface and Coatings Technology, 2008
- A comparative study of low temperature plasma nitriding, carburising and nitrocarburising of AISI 410 martensitic stainless steelMaterials Science and Technology, 2007
- Corrosion properties of plasma nitrided AISI 410 martensitic stainless steel in 3.5% NaCl and 1% HCl aqueous solutionsCorrosion Science, 2006
- Friction and rolling–sliding wear of DC-pulsed plasma nitrided AISI 410 martensitic stainless steelWear, 2006
- Microstructure and corrosion behaviour of DC-pulsed plasma nitrided AISI 410 martensitic stainless steelSurface and Coatings Technology, 2004
- On the kinetics of plasma nitriding a martensitic stainless steel type AISI 420Surface and Coatings Technology, 2004
- A study of martensitic stainless steel AISI 420 modified using plasma nitridingSurface and Coatings Technology, 2002
- Observation of a compound layer with very low friction coefficient in ion-nitrided martensitic 410 stainless steelSurface and Coatings Technology, 1998
- Wear behaviour of plasma-nitrided martensitic stainless steelWear, 1994