Introduction: Polymethyl Methacrylate (PMMA) has been used in dentistry for a long time due to its excellent aesthetics and ease of use. Polyether Ether Ketone (PEEK) has garnered attention for its potential in dental applications because of its remarkable mechanical properties and biocompatibility. Aim: To examine the Shear Bond Strength (SBS) of indirect composite resin when bonded to PEEK and PMMA, with assessments conducted before and after thermocycling. Materials and Methods: This in-vitro study was conducted at the Department of Prosthodontics and Implantology, Saveetha Dental College and Hospitals, Chennai, Tamil Nadu, India, from April 2023 to May 2023. The study included 44 samples, grouped into two: Group 1, consisting of 22 PMMA samples, and Group 2, comprising 22 PEEK samples. A total of 44 indirect composite samples were prepared using clear silicone moulds. The Ceresin Shofu bonding agent was used for bonding the PMMA and PEEK to the indirect composite and was light-cured. Subsequently, the two groups were further divided into four subgroups: Group 1A, with 11 PMMA samples subjected to the thermocycling process, and Group 1B, with 11 PMMA samples tested without thermocycling; Group 2A, consisting of 11 PEEK samples tested with the thermocycling process, and Group 2B, comprising 11 PEEK samples tested without thermocycling. The specimens underwent SBS testing after an immersion in distilled water for 24 hours at 37°C. SBS was measured using a universal testing machine, and statistical analysis was performed using parametric independent sample t-tests (α=0.05). Results: The study demonstrated a statistically significant difference in SBS for composites bonded to PMMA, which exhibited higher bond strength, with values of (7.922±0.285) MPa before thermocycling and (7.270±0.2694) MPa after thermocycling, revealing a significant difference (p<0.005). In contrast, the SBS for composite bonding to PEEK was slightly lower, with mean values of (5.520±0.341) MPa before thermocycling and (4.486±0.232) MPa afterwards (p<0.01). Conclusion: The SBS of PMMA bonded to indirect composite is higher than that of PEEK. Furthermore, it was noted that aging resulted in a reduction of bond strength for both PMMA and PEEK when bonded to indirect composite.