Adhesion of composite to enamel and dentin surfaces irradiated by IR laser pulses of 0.5–35 μs duration
Authors:
- 24 April 2006
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 79B (1) , 193-201
Abstract
The characteristics of laser‐treated tooth surfaces depend on the laser wavelength, pulse duration, spatial and temporal laser beam quality, incident fluence, surface roughness, and the presence of water during irradiation. Ablated surfaces are most commonly restored with adhesive dental materials and the characteristics of the ablated surfaces influence adhesion of restorative materials. Previous studies suggest that high bond strengths can be achieved using shorter laser pulses that minimize peripheral thermal damage. In this study, Er:YSGG, Er:YAG, and CO2 lasers were used at irradiation intensities sufficient to simulate efficient clinical caries removal to uniformly irradiate bovine enamel and human dentin surfaces using a motion control system with a microprocessor‐controlled water spray. The degree of spatial overlap of adjacent pulses was varied so as to investigate the influence of irradiation uniformity and surface roughness on the bond strength. Composite resin was bonded to the irradiated surfaces and shear bond tests were used to obtain bond strengths in MPa. The highest results were obtained using the Er:YAG pulses with pulse durations less than 35 μs without the necessity for postirradiation acid etching. Some of these groups were not significantly different from nonirradiated, acid‐etch‐only positive control groups. © 2006 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 2006Keywords
This publication has 19 references indexed in Scilit:
- Selective targeting of protein, water, and mineral in dentin using UV and IR pulse lasers: The effect on the bond strength to composite restorative materialsLasers in Surgery and Medicine, 2004
- Effect of an optically thick water layer during 9.6-μm CO 2 laser irradiation on caries inhibition2004
- Influence of an optically thick water layer on the bond‐strength of composite resin to dental enamel after IR laser ablationLasers in Surgery and Medicine, 2003
- SEM evaluation of the interaction pattern between dentin and resin after cavity preparation using ER:YAG laserJournal of Dentistry, 2003
- Effects of Er:YAG laser irradiation on human dentin: Polarizing microscopic, light microscopic and microradiographic observations, and FT‐IR analysisLasers in Surgery and Medicine, 2002
- Assessing Microleakage on Class V Composite Resin Restorations after Er:YAG Laser Preparation Varying the Adhesive SystemsJournal of Clinical Laser Medicine & Surgery, 2002
- Bonding to Er-YAG-laser-treated DentinJournal of Dental Research, 2002
- Adhesion of composite resins to enamel irradiated by the er:YAG laser: Application of the ultrasonic scaler on irradiated surfaceLasers in Surgery and Medicine, 2001
- Differences in bonding to acid-etched or Er:YAG-laser–treated enamel and dentin surfacesThe Journal of Prosthetic Dentistry, 2000
- Shear strength of composite bonded to laser-pretreated dentinThe Journal of Prosthetic Dentistry, 1988