Numerical Simulation of Carrier-Selective Electron Contacts Featuring Tunnel Oxides
Authors:
- 27 July 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 5 (5) , 1348-1356
Abstract
Recently, n-type Si solar cells featuring tunnel-oxide-passivated contacts have achieved remarkable conversion efficiencies of up to 24.9%. Different approaches concerning the doped Si layer, which can be amorphous, polycrystalline, or partially crystalline, have been presented over the past few years. In this paper, carrier-selective electron contacts featuring tunnel oxides are investigated by means of numerical device simulation. The influence of 1) the Si layer material, 2) the Si layer doping, 3) an additional in-diffusion in the absorber, 4) the surface recombination velocity at the oxide interface, and 5) the oxide thickness and the tunneling mass are investigated by means of an open-circuit voltage analysis, as well as a fill factor (FF) analysis. With the fundamental understanding generated in this paper, we are able to explain the excellent device performance of solar cells with carrier-selective contacts featuring tunnel oxides.Keywords
Funding Information
- German Federal Ministry for Economic Affairs and Energy (0325292, 0325447, 0325634)
This publication has 26 references indexed in Scilit:
- Tunnel oxide passivated contacts as an alternative to partial rear contactsSolar Energy Materials and Solar Cells, 2014
- Recombination behavior and contact resistance of n+ and p+ poly-crystalline Si/mono-crystalline Si junctionsSolar Energy Materials and Solar Cells, 2014
- >23% High-Efficiency Tunnel Oxide Junction Bifacial Solar Cell With Electroplated Cu GridlinesIEEE Journal of Photovoltaics, 2014
- Doped Layer Optimization for Silicon Heterojunctions by Injection-Level-Dependent Open-Circuit Voltage MeasurementsIEEE Journal of Photovoltaics, 2014
- Improved quantitative description of Auger recombination in crystalline siliconPhysical Review B, 2012
- Direct tunneling effective mass of electrons determined by intrinsic charge-up processSolid-State Electronics, 2007
- Determination of tunnel mass and physical thickness of gate oxide including poly-Si/SiO/sub 2/ and Si/SiO/sub 2/ interfacial transition LayersIEEE Transactions on Electron Devices, 2006
- A unified mobility model for device simulation—II. Temperature dependence of carrier mobility and lifetimeSolid-State Electronics, 1992
- A unified mobility model for device simulation—I. Model equations and concentration dependenceSolid-State Electronics, 1992
- The Richardson constant for thermionic emission in Schottky barrier diodesSolid-State Electronics, 1965