Electroless Plating of High-Performance Composite Pd Membranes with EDTA-Free Bath
Open Access
Abstract
High-performance composite Pd membranes were successfully fabricated using electroless plating with an EDTA-free bath. The plating started with employing the one-time addition of hydrazine. In the experiment, the hydrazine concentrations and plating bath volumes were systematically varied to optimize the plating. The optimum composite Pd membrane tube showed high H2 permeance of 4.4 × 10−3 mol/m2 s Pa0.5 and high selectivity of 1.6 × 104, but poor cycling stability. Then, a method of sequential addition of the hydrazine from the high to low concentrations was employed. The resultant membrane, about 6 μm thick, still exhibited a high selectivity of 6.8 × 104 as well as a much-improved plating yield and cycling stability level; this membrane outperformed the membrane made using the unmodified plating technique with the EDTA-contained bath. This result indicates the EDTA-free bath combined with the sequential addition of hydrazine is a simple, low-cost, yet effective method for preparing thin, dense composite Pd membranes featuring high hydrogen permeation flux and high thermal durability.Keywords
Funding Information
- National Science Council (102-2112-M-007-005-MY2)
This publication has 28 references indexed in Scilit:
- Electroless Pd membrane deposition on alumina modified porous Hastelloy substrate with EDTA-free bathInternational Journal of Hydrogen Energy, 2010
- Unsupported palladium alloy foil membranes fabricated by electroless platingJournal of Membrane Science, 2008
- Preparation of palladium membrane by electroplating on AISI 316L porous stainless steel supports and its use for methanol steam reformerJournal of Membrane Science, 2008
- A global survey of hydrogen energy research, development and policyEnergy Policy, 2006
- Defect‐free palladium membranes on porous stainless‐steel supportAIChE Journal, 1998
- CVD synthesis and gas permeation properties of thin palladium/alumina membranesAIChE Journal, 1998
- Fabrication of ultrathin metallic membranes on ceramic supports by sputter depositionJournal of Membrane Science, 1995
- Simultaneous deposition of Pd and Ag on porous stainless steel by electroless platingJournal of Membrane Science, 1993
- Catalytic palladium‐based membrane reactors: A reviewThe Canadian Journal of Chemical Engineering, 1991
- A Palladium/Porous-Glass Composite Membrane for Hydrogen SeparationChemistry Letters, 1988