Performance of obturation techniques in anatomical irregularities located at different thirds of the root canal system
Open Access
- 1 January 2024
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 32, e20230440
Abstract
This study aimed to compare the quality of root canal obturation (ratio of area occupied by gutta-percha (G), sealer (S), and presence of voids (V)) in different anatomical irregularities (intercanal communications, lateral irregularities, and accessory canals) located at different thirds of the root canal system of mandibular molar replicas. Sixty-seven 3D printed replicas of an accessed mandibular molar were prepared using ProGlider and ProTaper Gold rotatory systems. Three specimens were randomly selected to be used as controls and did not receive further treatment. The rest were randomly distributed in 4 experimental groups to be obturated using either cold lateral compaction (LC), continuous wave of condensation (CW), and core-carrier obturation (ThermafilPlus (TH) or GuttaCore (GC)) (n=16 per group). AHPlus® sealer was used in all groups. The three controls and a specimen from each experimental group were scanned using micro-computed tomography. The rest of the replicas were sectioned at the sites of anatomical irregularities and examined at 30× magnification. The G, S, and V ratios were calculated dividing the area occupied with each element by the total root canal area and then compared among groups using the Kruskal-Wallis test. Voids were present in all obturation techniques with ratios from 0.01 to 0.15. CW obtained a significantly higher G ratio in the irregularity located in the coronal third (0.882) than LC (0.681), TH (0.773), and GC (0.801) (pp<0.05). The worst quality of obturation was observed in the loop accessory canal with all obturation techniques. Whitin the limitations of this study, it can be concluded that CW and core-carrier obturation are respectively the most effective techniques for obturating anatomical irregularities located in the coronal and the apical third.Keywords
This publication has 29 references indexed in Scilit:
- Volumetric Evaluation of 5 Root Canal Obturation Methods in TrueTooth 3-dimensional–Printed Tooth Replicas Using Nano–computed TomographyJournal of Endodontics, 2021
- Microscopic and chemical evaluation of the filling quality of five obturation techniques in oval-shaped root canalsClinical Oral Investigations, 2020
- Percentage of Gutta-percha–filled Areas in Canals Obturated by 3 Different Techniques with and without the Use of Endodontic SealerJournal of Endodontics, 2018
- Evaluation of Different Techniques for Filling Simulated C-shaped Canals of 3-dimensional Printed Resin TeethJournal of Endodontics, 2017
- Presence of Voids after Continuous Wave of Condensation and Single-cone Obturation in Mandibular Molars: A Micro-computed Tomography AnalysisJournal of Endodontics, 2017
- Percentage of Gutta-percha Filled Areas in Canals Obturated with Cross-linked Gutta-percha Core-carrier Systems, Single-Cone and Lateral Compaction TechniqueJournal of Endodontics, 2016
- Middle mesial canals in mandibular first molars: A micro-CT study in different populationsArchives of Oral Biology, 2016
- Biofilms and Apical Periodontitis: Study of Prevalence and Association with Clinical and Histopathologic FindingsJournal of Endodontics, 2010
- Limited Ability of Three Commonly Used Thermoplasticized Gutta-Percha Techniques in Filling Oval-shaped CanalsJournal of Endodontics, 2008
- Sealer distribution in root canals obturated by three techniquesInternational Endodontic Journal, 2000