Tribological Characteristics of WC-Ni and WC-Co Cemented Carbide in Dry Reciprocating Sliding Contact
- 30 June 2009
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 52 (4) , 481-491
Abstract
Four WC-based cemented carbides produced by liquid phase sintering with different binder composition and similar carbide grain size were tested in order to evaluate their dry reciprocating sliding friction and wear behavior against WC-6 wt.%Co cemented carbide. The pin-on-flat wear experiments were executed on a Plint TE77 tribometer using normal contact loads of 15 N up to 35 N and a sliding velocity of 0.3 m/s. Analysis of the wear tracks revealed several wear mechanisms; i.e., polishing of WC grains, abrasion, adhesion, formation of wear debris layer, and removal of the surface binder from between the WC grains. Higher contact load increased the wear volume and slightly decreased the friction coefficient. The hardness as well as the type and the amount of binder phase were found to affect the wear resistance significantly. One WC-Ni alloy exhibited superior tribological characteristics compared to the other grades.Keywords
This publication has 22 references indexed in Scilit:
- Effects of Co content and WC grain size on wear of WC cemented carbideWear, 2006
- Experimental and numerical studies on the performance of alloyed carbide tool in dry milling of aerospace materialInternational Journal of Machine Tools and Manufacture, 2006
- Mechanical properties, phases and microstructure of ultrafine hardmetals prepared by WC–6.29Co nanocrystalline composite powderMaterials Science and Engineering: A, 2005
- Rotating wheel abrasion of WC/Co hardmetalsWear, 2005
- Wear of advanced cemented carbides for metalforming tool materialsWear, 2004
- Oxidation-induced strength degradation of WC–Co hardmetalsInternational Journal of Refractory Metals and Hard Materials, 2001
- Microstructure development during sintering and heat-treatment of cemented carbides and cermetsMaterials Chemistry and Physics, 2001
- Influence of VC on the microstructure and mechanical properties of WC–Co sintered cemented carbidesInternational Journal of Refractory Metals and Hard Materials, 1999
- Tribological performance evaluation of tungsten carbide-based cermets and development of a fracture mechanics wear modelWear, 1996
- Electrochemical behaviour of tungsten-carbide hardmetalsMaterials Science and Engineering: A, 1996