Benchmarking Digital Die-to-Die Channels in 2.5-D and 3-D Heterogeneous Integration Platforms
- 6 November 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (12) , 5460-5467
Abstract
In this paper, compact circuit models and HSPICE simulations are used to benchmark die-to-die communication channels in 2.5-D and 3-D heterogeneous integration platforms. The delay, energy-per-bit, and bandwidth-density of the considered integration platforms are simulated and benchmarked. Compared to other 2.5-D integrated systems with a 1-mm interconnect length, heterogeneous interconnect stitching technology (HIST)-based 2.5-D integration shows a maximum latency and energy reduction of 6.2% and 15.1%, respectively. 3-D ICs show further performance enhancement compared to 2.5-D integration; the link latency and energy are approximately 19.4% and 48.0% smaller than those of HIST (1-mm wire) for through-silicon via (TSV)-based 3-D integration (75-μm TSV height). Next, the impacts of the physical I/O interconnect dimensions and device process technology scaling are evaluated and we observe that advanced process technologies must be integrated with smaller physical I/O dimensions and shorter wire lengths to attain full advantages of scaling. Finally, we consider the thermal impact of dense heterogeneous integration and investigate the thermal and electrical signaling tradeoffs in 2.5-D and 3-D integration.Keywords
Funding Information
- National Science Foundation (CCF-1302297)
This publication has 20 references indexed in Scilit:
- TEI-powerACM Transactions on Design Automation of Electronic Systems, 2017
- Heterogeneous Interconnect Stitching Technology With Compressible MicroInterconnects for Dense Multi-Die IntegrationIEEE Electron Device Letters, 2016
- Embedded Multi-die Interconnect Bridge (EMIB) -- A High Density, High Bandwidth Packaging Interconnect2016
- Embedded cooling technologies for densely integrated electronic systems2015
- Thermal Design and Constraints for Heterogeneous Integrated Chip Stacks and Isolation Technology Using Air Gap and Thermal BridgeIEEE Transactions on Components, Packaging and Manufacturing Technology, 2014
- A Heterogeneous 3D-IC Consisting of Two 28 nm FPGA Die and 32 Reconfigurable High-Performance Data ConvertersIEEE Journal of Solid-State Circuits, 2014
- Power comparison of 2D, 3D and 2.5D interconnect solutions and power optimization of interposer interconnects2013
- Exploiting die-to-die thermal coupling in 3D IC placement2012
- Leakage current mechanisms and leakage reduction techniques in deep-submicrometer CMOS circuitsProceedings of the IEEE, 2003
- Sub-50 nm P-channel FinFETIEEE Transactions on Electron Devices, 2001