Drilling performance analysis on super duplex stainless steel (AISI 2507) using scalable pulse power plasma TiSiN- and AlTiN-coated tools and optimizing machining parameters through Taguchi–Fuzzy approach
- 16 August 2024
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 240 (2) , 2245-2255
Abstract
In recent years, super duplex stainless steel (SDSS) has gained a lot of importance due to its strength and excellent resistance to corrosion cracking for applications in marine and chemical processing industries, etc. In spite of various progress in the field, the drilling of SDSS leads to the formation of chips that are very strong and abrasive, which makes it challenging to have proper drilling. To overcome this issue by utilizing suitable parameters such as drill bit coating, environmental conditions and parameters for drilling. The SDSS machining output results were compared for both dry and minimum quantity lubrication (MQL) conditions using coated and uncoated drill bits. A scalable pulse power plasma (S3P) technique was utilized to deposit the titanium silicon nitride (TiSiN) and aluminum titanium nitride (AlTiN) coatings on solid carbide drill bits. In the experiments, three levels of drilling parameters have been chosen, including spindle speed (550, 700, 850 rpm), feed rate (0.035, 0.045, 0.060 m/min), and drill bit types. The experiment was designed using Taguchi's orthogonal L9 array. The influence of machining parameters such as cutting force, surface roughness, and circularity error were examined using variance analysis (ANOVA) and signal-to-noise (S/N) ratios. To enhance the drilling process parameters through a single comprehensive output measure, the obtained results were taken as an input to the fuzzy logic networks using multi-factor analysis. At the L7 trial, the least cutting force was observed at 525.7 N for dry conditions and 227.6 N for MQL conditions and gave cone-spiral and continuous chips. In order to analyze the signal-to-noise ratio effectively, high value correspond to better-quality characteristics. In accordance with ANOVA results pertaining to cutting force, a percentage contribution variance of 48.92% was obtained for the feed rate, which contributed to cutting force to a greater extent, followed by 36.82% for spindle speed and 14.19% for the type of drill bit.Keywords
This publication has 47 references indexed in Scilit:
- Statistical Analysis of the Effect of the Cutting Tool Coating Type on Sustainable Machining ParametersJournal of Materials Engineering and Performance, 2021
- Machinability evaluation of coated carbide inserts in turning of super-duplex stainless steelSN Applied Sciences, 2020
- Machinability Study of Duplex Stainless Steel 2205 During Dry TurningInternational Journal of Precision Engineering and Manufacturing, 2020
- Comparative study of PVD and CVD cutting tools performance in milling of duplex stainless steelThe International Journal of Advanced Manufacturing Technology, 2019
- Frictional and wear performance of hard coatings during machining of superduplex stainless steelThe International Journal of Advanced Manufacturing Technology, 2017
- Tribological behavior of superduplex stainless steel against PVD hard coatings on cemented carbideThe International Journal of Advanced Manufacturing Technology, 2016
- Optimization of bone drilling using Taguchi methodology coupled with fuzzy based desirability function approachJournal of Intelligent Manufacturing, 2013
- Ti/TiSiNO Multilayers Fabricated by Co-sputteringJournal of Materials Engineering and Performance, 2013
- Application of fuzzy logic for modeling surface roughness in turning CFRP composites using CBN toolProduction Engineering, 2011
- Optimizing feed force for turned parts through the Taguchi techniqueSādhanā, 2006