LPBF-Formed 2024Al Alloys: Process, Microstructure, Properties, and Thermal Cracking Behavior
Open Access
Abstract
2024Al is an Al-Cu-Mg series heat-treatable aluminum alloy with high strength and excellent damage resistance. To obtain a high-performance target component of LPBF-formed 2024Al, the effect of process parameters on density, microstructure, and performance is systematically investigated and the thermal cracking phenomenon is analyzed in detail. The results reveal that the optimization of process parameters can suppress the cracks generated during the LPBF forming of 2024Al to a certain extent. When the laser energy density is 741 J/mm3, the maximum density reaches 99.77%, whereas the tensile strength and elongation reach 330 ± 7 MPa and 9 ± 0.6%, respectively. Owing to the high Cu and Mg contents in 2024Al, the transverse strain rate of columnar grains during LPBF forming is easily higher than the sum of the transverse expansion rate of grains and the liquid phase filling rate at grain boundaries, resulting in strong thermal crack sensitivity. In addition, an extremely high cooling rate (−108 K/s) and heat input during LPBF forming reduce the liquid phase filling rate at grain boundaries to further aggravate the thermal cracking tendency. The current study provides experimental guidance for the preparation of high-quality, crack-less, or even crack-free 2024Al alloys.Keywords
Funding Information
- National Natural Science Foundation of China (52005391)
This publication has 29 references indexed in Scilit:
- Evidence of back diffusion reducing cracking during solidificationActa Materialia, 2017
- Crack susceptibility of binary aluminum alloys during solidificationActa Materialia, 2016
- Selective laser melting of high strength Al–Cu–Mg alloys: Processing, microstructure and mechanical propertiesMaterials Science and Engineering: A, 2016
- Formation and reduction of hydrogen porosity during selective laser melting of AlSi10MgJournal of Materials Processing Technology, 2015
- A criterion for cracking during solidificationActa Materialia, 2015
- Microstructure and mechanical properties of Al–12Si produced by selective laser melting: Effect of heat treatmentMaterials Science and Engineering: A, 2014
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013
- Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titaniumActa Materialia, 2012
- A Smoothing Filter for Misorientation Mapping Obtained by EBSDMATERIALS TRANSACTIONS, 2010
- A new hot-tearing criterionMetallurgical and Materials Transactions A, 1999