A novel fabrication method of carbon electrodes using 3D printing and chemical modification process
- 23 November 2017
- journal article
- research article
- Published by Springer Nature in Biomedical Microdevices
- Vol. 20 (1) , 4
Abstract
Three-dimensional (3D) printing is an emerging technique in the field of biomedical engineering and electronics. This paper presents a novel biofabrication method of implantable carbon electrodes with several advantages including fast prototyping, patient-specific and miniaturization without expensive cleanroom. The method combines stereolithography in additive manufacturing and chemical modification processes to fabricate electrically conductive carbon electrodes. The stereolithography allows the structures to be 3D printed with very fine resolution and desired shapes. The resin is then chemically modified to carbon using pyrolysis to enhance electrochemical performance. The electrochemical characteristics of 3D printing carbon electrodes are assessed by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The specific capacitance of 3D printing carbon electrodes is much higher than the same sized platinum (Pt) electrode. In-vivo electromyography (EMG) recording, 3D printing carbon electrodes exhibit much higher signal-to-noise ratio (40.63 ± 7.73) than Pt electrodes (14.26 ± 6.83). The proposed biofabrication method is envisioned to enable 3D printing in many emerging applications in biomedical engineering and electronics.Keywords
Funding Information
- National Natural Science Foundation of China (51675329)
- National Science Foundation CAREER Award (1055932)
- National Science Foundation MRI Award (1229635)
- Innovative Methods Program of Ministry of Science and Technology of China (2015IM010100)
- National Key R&D Program of China (2016YFC0104104, 2016YFF0101602)
- Shanghai Committee of Science and Technology (15142200800, 16XD1425000, 16441906000)
- the State Key Laboratory of Mechanical System and Vibration (MSV201601)
- the Cross Fund for medical and Engineering of Shanghai Jiao Tong University (YG2014MS12)
This publication has 43 references indexed in Scilit:
- SU-8/MWCNT derived Electrospun Composite Carbon Nanofabric as a High Performance Anode Material for Lithium Ion BatteryECS Transactions, 2016
- Additive manufacturing of polymer-derived ceramicsScience, 2016
- 3D printed microfluidics for biological applicationsLab on a Chip, 2015
- Three-Dimensional Printing of High-Content Graphene Scaffolds for Electronic and Biomedical ApplicationsACS Nano, 2015
- Performance of conducting polymer electrodes for stimulating neuroprostheticsJournal of Neural Engineering, 2013
- Integrating stereolithography and direct print technologies for 3D structural electronics fabricationRapid Prototyping Journal, 2012
- Neural Stimulation and Recording ElectrodesAnnual Review of Biomedical Engineering, 2008
- Levofloxacin implants with predefined microstructure fabricated by three-dimensional printing techniqueInternational Journal of Pharmaceutics, 2007
- Structural characterization of carbon nanofibers obtained by hydrocarbon pyrolysisCarbon, 2001
- A review of investigations on biocompatibility of diamond-like carbon and carbon nitride filmsSurface and Coatings Technology, 2000