Comparative Analysis of Microchannel Heat Sink Configurations Subject to a Pressure Constraint
- 1 January 2009
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 30 (1-2) , 43-53
Abstract
Leakage losses and ever-increasing power dissipation in the microprocessor are causing significant thermal, mechanical, and reliability problems. Conventional cooling methods are reaching their practical limits, and new methods of lowering the operating temperature of microprocessors are being explored. Microfluidics-based cooling schemes are one approach being considered. The implementation of microchannels for forced convection at the chip level shows much promise, as the effective heat transfer surface area and attainable heat flux are very favorable. A major design limitation to such an implementation is the pressure developed within such micro-flows and the stresses that could result. In this study, multiple discrete microchannel heat sink configurations are analyzed computationally and compared in a cooling capability sense, while total pressure drop across the flows is carefully considered. A single cooling channel over an energy source is split into two smaller channels, and so on, while total pressure drop is maintained constant, and specified such that all flows remain in the laminar regime. It is shown that for the configurations analyzed, there exists multiple-dependence optimum cooling configurations. In addition, it is shown that a slimmer design may be implemented with a relatively small effect on cooling capability. Furthermore, cooling capability dependence on total pressure drop of the flows is shown to be minimal for high-performing microchannel configurations.Keywords
This publication has 19 references indexed in Scilit:
- Experimental and Computational Investigation of Flow Development and Pressure Drop in a Rectangular Micro-channelJournal of Electronic Packaging, 2005
- Viscous heating in liquid flows in micro-channelsInternational Journal of Heat and Mass Transfer, 2005
- Three-dimensional analysis of heat transfer in a micro-heat sink with single phase flowInternational Journal of Heat and Mass Transfer, 2004
- Single-phase convective heat transfer in microchannels: a review of experimental resultsInternational Journal of Thermal Sciences, 2004
- Experimental investigation of flow friction for liquid flow in microchannelsInternational Communications in Heat and Mass Transfer, 2000
- Constrained optimal duct shapes for conjugate laminar forced convectionInternational Journal of Heat and Mass Transfer, 2000
- MICRO-ELECTRO-MECHANICAL-SYSTEMS (MEMS) AND FLUID FLOWSAnnual Review of Fluid Mechanics, 1998
- The effect of thermofluid and geometrical parameters on convection of liquids through rectangular microchannelsInternational Journal of Heat and Mass Transfer, 1995
- Experimental investigation on liquid forced-convection heat transfer through microchannelsInternational Journal of Heat and Mass Transfer, 1994
- High-performance heat sinking for VLSIIEEE Electron Device Letters, 1981