Effect of Cr Doping Content on the Mechanical and Tribological Properties of Cr-C/DLC Films on ACM Rubber Surfaces
Open Access
- 31 March 2026
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 14 (4) , 148
Abstract
Recently, diamond-like carbon (DLC) films have been considered for enhancing the wear resistance of rubber because rubber exhibits a high coefficient of friction and is prone to wearing out. However, the significant difference in thermal expansion coefficients between DLC films and rubber often leads to high residual stresses and poor interfacial adhesion, which limits their application in dynamic seals. In this study, Cr-C/DLC composite films were prepared using magnetron sputtering, and the effects of varying Cr contents (0.8 at.%, 1.4 at.%, 4.3 at.%, and 7.0 at.%) on interfacial adhesion and tribological properties were investigated. Scanning electron microscopy (SEM) analysis revealed no distinct demarcation lines in the composite films, indicating strong adhesion to the substrate. X-ray photoelectron spectroscopy (XPS) analysis revealed that chromium doping promoted the conversion of sp3 bonds to sp2 bonds. Adhesion and tribology tests revealed that introducing a Cr-C layer with higher Cr content within the range of 0.8 at.% to 7.0 at.% enhanced the film’s adhesion, reducing the CoF value of the composite film to 0.13–0.14. Specifically, the RF80 sample (4.3 at.% Cr) exhibited excellent interfacial adhesion and optimal tribological performance, with a CoF value reduced to 0.13 and wear rate of 3.1 × 10−4 mm3/(Nm). In summary, modulating the Cr doping content can significantly enhance the interfacial adhesion strength and tribological properties of Cr-C/DLC composite films on rubber surfaces, providing an effective solution for optimizing rubber seals.Keywords
Funding Information
- Hainan Provincial Department of Science and Technology (420RC525)
- Hainan Provincial Department of Science and Technology (ZDYF2019206)
- State Key Laboratory of Advanced Refractories (SKLAR-KF-2025-06)
This publication has 45 references indexed in Scilit:
- Structure and properties of ta-C films prepared by vacuum cathodic arc with an unbalanced external electromagnetic fieldCeramics International, 2022
- A new method to measure the three-dimensional solubility parameters of acrylate rubber and predict its oil resistancePolymer Bulletin, 2021
- Adhesion and friction performance of DLC/rubber: The influence of plasma pretreatmentFriction, 2021
- Structural, mechanical and tribocorrosion performances of CrMoSiN coatings with various Mo contents in artificial seawaterApplied Surface Science, 2020
- Mechanical and cutting performance of cemented carbide tools with Cr/x/DLC composite coatingsThe International Journal of Advanced Manufacturing Technology, 2020
- Apparent depth‐dependent modulus and hardness of polymers by nanoindentation: Investigation of surface detection error and pressure effectsJournal of Polymer Science Part B: Polymer Physics, 2017
- Effects of Cr concentrations on the microstructure, hardness, and temperature-dependent tribological properties of Cr-DLC coatingsApplied Surface Science, 2013
- Flexible diamond-like carbon films on rubber: Friction and the effect of viscoelastic deformation of rubber substratesActa Materialia, 2012
- Bonding in hydrogenated diamond-like carbon by Raman spectroscopyDiamond and Related Materials, 2005
- Interfacial forces in aqueous mediaProgress in Organic Coatings, 1995