Viscosity and heat transfer in fluidized snow
Authors:
Open Access
- 1 January 1980
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Glaciology
- Vol. 26 (94) , 263-274
Abstract
Fluidized snow was produced in a cold laboratory and its viscosity and heat transfer were studied. The viscosity of the fluidized snow was measured with a modified Stormer-type viscometer. It was found that the apparent viscosity decreased with increasing air velocity and decreasing particle diameter. Two mechanisms were suggested as producing the viscosity of the fluidized snow on the basis of the plot of the viscosity against the reciprocal of the air velocity. The heat-transfer coefficient was obtained by measuring the temperature of a cooled brass sphere suspended in the fluidized snow. The heat-transfer coefficient in the fluidized snow was three or four times larger than that in an air flow containing no snow particles. The increase was attributed to the enhanced turbulence of air flow and the collision of snow particles; the contribution of the latter was estimated to be 80 to 90% of the total increase due to the fluidization of snow. These results were also confirmed in an artificial blowing snow produced in a cold horizontal wind-tunnel by measuring the heat-transfer coefficient, wind velocity, and drift density. Résumé De la neige en suspension est produite dans un laboratoire froid et on étudie sa viscosité et ses propriét és de transfert thermique. La viscosité de la neige en suspension a été mesurée avec un viscosimétre modifié du type de Stormer, On a trouvé que la viscosité apparente diminue lorsque croit la vitesse de l’air et que décroit le diamétre des particules. On suggére deux mécanismes pour travailler sur la viscosité de la neige en suspension sur la base d’un diagramme de la viscosit é en fonction de l’inverse de la vitesse de l’air. Le coefficient de transfert thermique est obtenu en mesurant la température d’unc sphére de laiton refroidie suspendue dans la neige en suspension. Le coefficient du transfert thermique dans la neige en suspension est deux ou trois fois plus grand que dans un courant d’air sans particules en suspension. Cet accroissement est attribué à l’obstacle opposé à la turbulence de l’air et aux chocs entreparticules; la contribution de ce dernier phénoméne est estimé expliquer 80 à 90% de l’accroissement total dȗ à la présence de neige en suspension. Ces résultats sont également confirmés dans un courant de chasse neige artificiel produit dans un tunnel froid horizontal où l’on mesurait le coefficient de transfert thermique, la vitesse du vent et la densité du chasse-neige. Zusammenfassung Die Viskosität und Wärmeleitung fliessenden Schnees, hergestellt in einem Kältelabor, wurden untersucht. Die Viskosität wurde mit einem modifizierten Viskometer vom Stormer-Typ gemessen. Es zeigte sich, dass die scheinbare Viskosität mit wachsender Luftgeschwindigkeit und mit abnehmendem Partikeldurchmesser abnahm. Aus der Aufzeich- nung der Viskosität gegen den Kehrwert der Luftgeschwindigkeit lässt sich die Wirkung zweier Mechanismen auf die Viskosität des fliessenden Schnees folgern. Der Wärmekoeffizient wurde durch Messung der Temperatur einer gekühlten Messingkugel erhalten, die im fliessenden Schnee hing; er ergab sich drei- oder viermal grösser als der in einem Luftstrom ohne Sehneepartikel. Sein Anwachscn lässt sich der erhöhten Turbulenz des Luftstroms und der Kollision zwischen Schneepartikel zuschreiben; der Beitrag der letzteren wurde auf 80 bis 90% der gesamten Zunahme infolge des Schneefliessens abgeschätzt. Diese Ergebnisse wurden auch durch Messung des Wärmckoeffizienten, der Luftgeschwindigkeit und der Driftdichte in Schnee bestätigt, der in einem kalten horizontalen Windkanal künstlich verblasen wurde.Keywords
This publication has 8 references indexed in Scilit:
- Fluidization of snowCold Regions Science and Technology, 1979
- Heat and Maas Transfer on the Surface of Solid Spheres Fixed within Fluidized BedsChemical engineering, 1965
- Effects of Solid Thermal Properties on Heat Transfer to Gas Fluidized BedsIndustrial & Engineering Chemistry Fundamentals, 1964
- Liquidlike Properties of Fluidized SystemsIndustrial & Engineering Chemistry, 1958
- On the “viscosity” of a bed of fluidized solidsChemical Engineering Science, 1951
- Characteristics of Fluid-Solid SystemsIndustrial & Engineering Chemistry, 1949
- Temperature Charts for Induction and Constant-Temperature HeatingTransactions of the American Society of Mechanical Engineers, 1947
- Charts for Estimating Temperature Distributions in Heating or Cooling Solid Shapes.Industrial & Engineering Chemistry, 1923