Three methods for characterizing thermo-optic noise in optical cavities
- 17 December 2018
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review D
- Vol. 98 (12) , 122004
Abstract
Thermo-optic noise is likely to be the dominant noise source in next generation ultralow noise optical cavities. We developed three measurement and analysis methods, allowing us to estimate the level of coating thermo-optic noise in optical cavities, including interferometric gravitational wave detectors. We measured the shift in the broadband transmission spectra as a function of temperature for single-layer, high index coatings in order to find the thermo-optic coefficient, , of a coating while assuming the thermal expansion coefficient, . Our value for could then be used to calculate the thermo-optic noise in any high-finesse optical cavity using coatings with the same high index layer material. We also measured the spectra as a function of temperature of a multilayer, high-reflectivity coating where the material composition of the layers was similar to the coatings installed in Advanced LIGO. This method has the advantage of allowing us to calculate thermo-optic noise directly; and do not need to be known separately, although we do need to know the value of the overall coating thermal expansion coefficient. Finally, we used lasers of different wavelengths to measure transmission changes on the band edges of a multilayer high-reflectivity coating. This gave measurements with high statistical precision but potentially lower systematic accuracy. To address systematic accuracy concerns, we used a constrained Monte Carlo application of the theory of multilayer coating transmission.
Keywords
Funding Information
- University of Arizona
- National Science Foundation (NSF-0601135, NSF-0757999)
This publication has 30 references indexed in Scilit:
- Thermo-optic noise in coated mirrors for high-precision optical measurementsPhysical Review D, 2008
- Measurement of the thermal conductivity of TiO2 thin films by using the thermo-reflectance methodThermochimica Acta, 2007
- Titania-doped tantala/silica coatings for gravitational-wave detectionClassical and Quantum Gravity, 2006
- Thermoelastic dissipation in inhomogeneous media: loss measurements and displacement noise in coated test masses for interferometric gravitational wave detectorsPhysical Review D, 2004
- Experimental measurements of coating mechanical loss factorsClassical and Quantum Gravity, 2004
- Quantum noise in second generation, signal-recycled laser interferometric gravitational-wave detectorsPhysical Review D, 2001
- Effect of thermal stresses on temperature dependence of refractive index for Ta2O5 dielectric filmsThin Solid Films, 1999
- Absorption and thermal conductivity of oxide thin films measured by photothermal displacement and reflectance methodsApplied Optics, 1993
- Stress-optic effects, birefringence, and reduction of birefringence by annealing in fiber Fabry-Perot interferometersJournal of Lightwave Technology, 1988
- Irreversibility and Generalized NoisePhysical Review B, 1951