An objective meta-modeling approach for indentation-based material characterization
Authors:
- Liang MengLMLiang Meng
- Balaji RaghavanBRBalaji Raghavan
- Olivier BartierOBOlivier Bartier
- Xavier HernotXHXavier Hernot
- Gerard MauvoisinGMGerard Mauvoisin
- Piotr BreitkopfPBPiotr Breitkopf
- 1 April 2017
- journal article
- Published by Elsevier in Mechanics of Materials
- Vol. 107, 31-44
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (11620101002)
- China Scholarship Council (201404490062)
This publication has 77 references indexed in Scilit:
- An inverse analysis approach based on a POD direct model for the mechanical characterization of metallic materialsComputational Materials Science, 2014
- Mechanical property measurements of heterogeneous materials by selective nanoindentation: Application to LiMn2O4 cathodeMaterials Science and Engineering: A, 2014
- An alternative to the determination of the effective zero point in instrumented indentation: Use of the slope of the indentation curve at indentation load valuesMaterials & Design (1980-2015), 2012
- Influence of sample thickness and experimental device configuration on the spherical indentation of AISI 1095 steelJournal of Materials Research, 2011
- Material-dependent representative plastic strain for the prediction of indentation hardnessActa Materialia, 2010
- Theoretical and experimental analysis of contact radius for spherical indentationMechanics of Materials, 2010
- Indentation and imprint mapping method for identification of residual stressesComputational Materials Science, 2007
- Indentation and imprint mapping for the identification of constitutive parameters of thin layers on substrate: Perfectly bonded interfacesMaterials Science and Engineering: A, 2007
- Absence of one-to-one correspondence between elastoplastic properties and sharp-indentation load–penetration dataJournal of Materials Research, 2005
- Mechanical properties of materials studied from kinetic diagrams of load versus depth of impression during microimpressionStrength of Materials, 1976