Metal oxide nanograined chemosensor: Influence of film microstructure on gas sensing
- 1 February 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
In this work the case of spherical grains will be discussed in order to point out that the reduction of the sensing film grain size changes the behavior, not always giving a better performance in terms of sensitivity, with respect to large grained films. The model was focused on p-type materials and some simulation results for YCoO3 are shown and discussed.Keywords
This publication has 7 references indexed in Scilit:
- NOx Sensors Based on YCoO3 Perovskite2015
- Gas-sensing properties and modeling of silver doped potassium hollanditeSensors and Actuators B: Chemical, 2014
- Metal-oxide nanowire sensors for CO detection: Characterization and modelingSensors and Actuators B: Chemical, 2010
- Surface State Model for Conductance Responses During Thermal-Modulation of SnO-Based Thick Film Sensors: Part IModel DerivationIEEE Transactions on Instrumentation and Measurement, 2006
- Temperature dependence of electrical resistivity for Ca-doped perovskite-type Y1−xCaxCoO3 prepared by sol–gel processJournal of Physics and Chemistry of Solids, 2006
- CO sensing with SnO2-based thick film sensors: Surface state model for conductance responses during thermal-modulationSensors and Actuators B: Chemical, 2006
- Dynamic CO recognition in presence of interfering gases by using one MOX sensor and a selected temperature profileSensors and Actuators B: Chemical, 2005