Static and Impact-Dynamic Characterization of Multiphase TRIP Steels
Authors:
- 12 January 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 638-642, 3585-3590
Abstract
In this study, results are presented of an extensive experimental program to investigate the strain rate dependent mechanical properties of various Transformation Induced Plasticity (TRIP) steel grades. A split Hopkinson tensile bar setup was used for the high strain rate experiments and microstructural observation techniques such as LOM, SEM and EBSD revealed the mechanisms governing the observed behavior. With elevated testing temperatures and interrupted tensile experiments the material behavior and the austenite to martensite transformation is investigated. In dynamic conditions, the strain rate has limited influence on the material properties. Yet an important increase is noticed when comparing static to dynamic conditions. The differences in strength, elongation and energy absorption levels observed between the investigated materials can be attributed to their chemical composition. Adiabatic heating during high strain rate deformation tends to slow down the strain induced martensitic deformation. The elongation of the ferritic and austenite constituents is found to be strain rate dependent and the strain induced martensitic transformation occurs gradually in the material.Keywords
This publication has 7 references indexed in Scilit:
- Evaluation of the Static Stress-Strain Behaviour of Phosphorus Alloyed and Titanium Micro-alloyed TRIP SteelsSteel Research International, 2008
- The effect of silicon, aluminium and phosphor on the dynamic behavior and phenomenological modelling of multiphase TRIP steelsMetals and Materials International, 2007
- On the influence of interactions between phases on the mechanical stability of retained austenite in transformation-induced plasticity multiphase steelsMetallurgical and Materials Transactions A, 2001
- Hopkinson techniques for dynamic recovery experimentsProceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences, 1991
- The deformation of metals under small stresses during phase transformationsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1965
- An Investigation of the Mechanical Properties of Materials at very High Rates of LoadingProceedings of the Physical Society. Section B, 1949
- X. A method of measuring the pressure produced in the detonation of high, explosives or by the impact of bulletsPhilosophical Transactions of the Royal Society A, 1914