Numerical Simulation of Material Flow and Analysis of Welding Characteristics in Friction Stir Welding Process
Open Access
Abstract
Friction stir welding (FSW) material flow has an important influence on weld formation. The finite element model of the FSW process was established. The axial force and the spindle torque of the welding process were collected through experiments. The feasibility of the finite element model was verified by a data comparison. The temperature field of the welding process was analyzed hierarchically. It was found that the temperature on the advancing side is about 20 °C higher than that on the retreating side near the welding seam, but that the temperature difference between the two sides of the middle and lower layers was decreased. The particle tracking technique was used to study the material flow law in different areas of the weld seam. The results showed that part of the material inside the tool pin was squeezed to the bottom of the workpiece. The material on the upper surface tends to move downward under the influence of the shoulder extrusion, while the material on the lower part moves spirally upward under the influence of the tool pin. The material flow amount of the advancing side is higher than that of the retreating side. The law of material flow reveals the possible causes of the welding defects. It was found that the abnormal flow of materials at a low rotation speed and high welding speed is prone to holes and crack defects. The forming reasons and material flow differences in different regions are studied through the microstructure of the joint cross section. The feasibility of a finite element modeling and simulation analysis is further verified.Keywords
Funding Information
- National Natural Science Foundation of China (51505470)
- Youth Innovation Promotion Association of the Chinese Academy of Sciences (2018237)
- ‘JXS’ innovation fund, SIA. (20180504)
This publication has 38 references indexed in Scilit:
- Relationship between material flow and abnormal grain growth in friction-stir weldsScripta Materialia, 2012
- Characteristics and Formation Mechanisms of Welding Defects in Underwater Friction Stir Welded Aluminum AlloyMetallography, Microstructure, and Analysis, 2012
- Numerical simulation of material flow behavior of friction stir welding influenced by rotational tool geometryComputational Materials Science, 2012
- Simulation of material flow in friction stir processing of a cast Al–Si alloyMaterials & Design (1980-2015), 2012
- Effect of Alclad Layer on Material Flow and Defect Formation in Friction-Stir-Welded 2024 Aluminum AlloyMetallurgical and Materials Transactions A, 2010
- Tensile properties of a friction stir welded magnesium alloy: Effect of pin tool thread orientation and weld pitchMaterials Science and Engineering: A, 2010
- Friction model for friction stir welding process simulation: Calibrations from welding experimentsInternational Journal of Machine Tools and Manufacture, 2010
- Material flow in heterogeneous friction stir welding of thin aluminium sheets: Effect of shoulder geometryMaterials Science and Engineering: A, 2008
- Shear flow and formation of Nugget zone during friction stir welding of aluminium alloy 5083-OMaterials Science and Engineering: A, 2008
- A continuum based fem model for friction stir welding—model developmentMaterials Science and Engineering: A, 2006