Effect of machining on the stress corrosion cracking behavior in boiling magnesium chloride solution of austenitic stainless steel
Authors:
- 10 November 2017
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 69 (4) , 519-526
Abstract
The stress corrosion cracking (SCC) behaviors of Z3CN20.09M, 304L, and 316L austenitic stainless steels (SSs) after milling operation in boiling magnesium chloride solution were investigated by scanning electron microscopy (SEM), X‐ray diffraction, and 3D profilometer. The experimental results indicated that the roughness and residual stress increased with increasing feed rate of all specimens. The depth of deformation layer after milling operation reached about 150 µm shown as persistent slip bands (PSBs) were formed, leading to hardness enhanced obviously. After SCC tests in boiling magnesium chloride solution, the crack densities increased with increasing feed rate of the Z3CN20.09M SS specimens. However, the crack densities decreased as well as the intergranular (IG) cracking percentages increased with increasing feed rate of the 304L and 316L SS.Keywords
Funding Information
- National Natural Science Foundation of China (51375182)
- China Postdoctoral Science Foundation (2016M601887)
This publication has 32 references indexed in Scilit:
- Effect of machining-induced surface residual stress on initiation of stress corrosion cracking in 316 austenitic stainless steelCorrosion Science, 2016
- Effect of sigma phase on the low cycle fatigue property of Z3CN20.09M cast duplex stainless steel in high temperature waterMaterials and Corrosion, 2014
- Behavior of stainless steels in pressurized water reactor primary circuitsJournal of Nuclear Materials, 2012
- Effects of pH and dissolved oxygen on electrochemical behavior and oxide films of 304SS in borated and lithiated high temperature waterCorrosion Science, 2012
- Modeling of SCC initiation and propagation mechanisms in BWR environmentsNuclear Engineering and Design, 2011
- Stress corrosion cracking of uni-directionally cold worked 316NG stainless steel in simulated PWR primary water with various dissolved hydrogen concentrationsCorrosion Science, 2011
- Detection and characterisation of intergranular stress‐corrosion cracking on austenitic stainless steelMaterials and Corrosion, 2011
- Localized deformation as a key precursor to initiation of intergranular stress corrosion cracking of austenitic stainless steels employed in nuclear power plantsJournal of Nuclear Materials, 2010
- Effects of temperature on the oxide film properties of 304 stainless steel in high temperature lithium borate buffer solutionCorrosion Science, 2009
- Recent developments in stainless steelsMaterials Science and Engineering: R: Reports, 2009