Magnetoelectric thin film composites with interdigital electrodes
- 15 July 2013
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 103 (3) , 032902
Abstract
Magnetoelectric (ME) thin film composites on silicon cantilevers are fabricated using Pb(Zr0.52Ti0.45)O3 (PZT) films with interdigital transducer electrodes on the top side and FeCoSiB amorphous magnetostrictive thin films on the backside. These composites without any direct interface between the piezoelectric and magnetostrictive phase are superior to conventional plate capacitor-type thin film ME composites. A limit of detection of 2.6 pT/Hz1/2 at the mechanical resonance is determined which corresponds to an improvement of a factor of approximately 2.8 compared to the best plate type sensor using AlN as the piezoelectric phase and even a factor of approximately 4 for a PZT plate capacitor.Keywords
This publication has 22 references indexed in Scilit:
- Sensitivity enhancement of magnetoelectric sensors through frequency-conversionSensors and Actuators A: Physical, 2012
- Exchange biasing of magnetoelectric compositesNature Materials, 2012
- Magnetoelectric sensors for biomagnetic measurements2011
- Low damping resonant magnetoelectric sensorsApplied Physics Letters, 2010
- Giant magnetoelectric coefficients in (Fe90Co10)78Si12B10-AlN thin film compositesApplied Physics Letters, 2010
- Fabrication and characterization of all-thin-film magnetoelectric sensorsApplied Physics Letters, 2009
- Thin film magnetoelectric composites near spin reorientation transitionJournal of Magnetism and Magnetic Materials, 2009
- Magnetoelectric effect near spin reorientation transition in giant magnetostrictive-aluminum nitride thin film structureApplied Physics Letters, 2008
- Detection of pico-Tesla magnetic fields using magneto-electric sensors at room temperatureApplied Physics Letters, 2006
- Revival of the magnetoelectric effectJournal of Physics D: Applied Physics, 2005