Solution‐crystallization and related phenomena in 9,9‐dialkyl‐fluorene polymers. II. Influence of side‐chain structure
Open Access
- 17 August 2015
- journal article
- research article
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 53 (21) , 1492-1506
Abstract
Solution-crystallization is studied for two polyfluorene polymers possessing different side-chain structures. Thermal analysis and temperature-dependent optical spectroscopy are used to clarify the nature of the crystallization process, while X-ray diffraction and scanning electron microscopy reveal important differences in the resulting microstructures. It is shown that the planar-zigzag chain conformation termed the β-phase, which is observed for certain linear-side-chain polyfluorenes, is necessary for the formation of so-called polymer-solvent compounds for these polymers. Introduction of alternating fluorene repeat units with branched side-chains prevents formation of the β-phase conformation and results in non-solvated, i.e. melt-crystallization-type, polymer crystals. Unlike non-solvated polymer crystals, for which the chain conformation is stabilized by its incorporation into a crystalline lattice, the β-phase conformation is stabilized by complexation with solvent molecules and, therefore, its formation does not require specific inter-chain interactions. The presented results clarify the fundamental differences between the β-phase and other conformational/crystalline forms of polyfluorenes. © 2015 The Authors. Journal of Polymer Science Part B: Polymer Physics published by Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015, 53, 1492–1506Keywords
Funding Information
- UK Engineering and Physical Sciences Research Council (EP/H000917/1)
This publication has 78 references indexed in Scilit:
- Inkjet printing of organic electronics – comparison of deposition techniques and state-of-the-art developmentsJournal of Materials Chemistry C, 2012
- Gravure printing inverted organic solar cells: The influence of ink properties on film quality and device performanceSolar Energy Materials and Solar Cells, 2012
- Gravure printing for three subsequent solar cell layers of inverted structures on flexible substratesSolar Energy Materials and Solar Cells, 2011
- High performance, flexible polymer light-emitting diodes (PLEDs) with gravure contact printed hole injection and light emitting layersOrganic Electronics, 2010
- Materials and Applications for Large Area Electronics: Solution-Based ApproachesChemical Reviews, 2010
- Polymer Field‐Effect Transistors Fabricated by the Sequential Gravure Printing of Polythiophene, Two Insulator Layers, and a Metal Ink GateAdvanced Functional Materials, 2010
- Conjugated polymer aggregates in solution: Control of interchain interactionsThe Journal of Chemical Physics, 1999
- Chain geometry, solution aggregation and enhanced dichroism in the liquidcrystalline conjugated polymer poly(9,9-dioctylfluorene)Acta Polymerica, 1998
- Large changes in optical response through chemical pre‐ordering of poly(p‐phenylenevinylene)Advanced Materials, 1993
- Light-emitting diodes based on conjugated polymersNature, 1990