Influence of deposition conditions on mechanical properties of low-pressure chemical vapor deposited low-stress silicon nitride films
Authors:
- 15 November 2003
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 94 (10) , 6915-6922
Abstract
The effect of deposition temperature, deposition pressure, or input gas ratio on film stress was determined for low-pressure chemical vapor deposited silicon nitride films. Wafer curvature measurements were performed for films deposited on single crystal silicon and amorphous silica wafer substrates to determine film stress biaxial modulus and coefficient of thermal expansion Apparent plane strain film modulus and hardness H were measured using depth-sensing indentation. Ellipsometry was used to measure film thickness and refractive index n. Infrared spectroscopy, x-ray photoelectron spectroscopy (XPS), forward recoil energy spectroscopy (FReS), and Rutherford backscattering spectroscopy (RBS) experiments were performed to determine film composition. Although film deposition stress varied from −135 MPa (compressive) to 235 MPa (tensile) H, and remained nearly constant. Infrared spectroscopy resolved only Si-N species for all films, and results from FReS on three films confirmed that the hydrogen content was negligible. RBS and XPS indicated that Si/N increased with increased compressive Ellipsometry and RBS indicated that all films were silicon-rich, to a greater extent with increased compressive As RBS indicated that atomic density decreased with increased compressive deposition stress, it was concluded that the deposition conditions changed both thermal and intrinsic deposition stress for all films. In particular, intrinsic stress was tensile, and became increasingly tensile for increased Si/N and decreased atomic density. Assuming thermal stress was similar for all films examined here, the intrinsic stress must have varied from changes dependent on the deposition conditions.
Keywords
This publication has 35 references indexed in Scilit:
- Fabrication of functional structures on thin silicon nitride membranesMicroelectronic Engineering, 2003
- Micromachined piezoelectric membrane acoustic deviceSensors and Actuators A: Physical, 2003
- Nanomechanical resonant structures in silicon nitride: fabrication, operation and dissipation issuesSensors and Actuators A: Physical, 2002
- A micromachined magnetostrictive pressure sensor using magneto-optical interrogationSensors and Actuators A: Physical, 2000
- Simulation and fabrication of piezoresistive membrane type MEMS strain sensorsSensors and Actuators A: Physical, 2000
- Low Temperature Thermal Chemical Vapor Deposition of Silicon Nitride Thin Films for Microelectronics ApplicationsMRS Proceedings, 1999
- Surface micromachining for microelectromechanical systemsProceedings of the IEEE, 1998
- Micromachined pressure sensors: review and recent developmentsSmart Materials and Structures, 1997
- Optimization of a low-stress silicon nitride process for surface-micromachining applicationsSensors and Actuators A: Physical, 1997
- The preparation, characterization and applications of silicon nitride thin filmsThin Solid Films, 1980